3Com 7000HD manual Removing the 16MB Memory Simm

Page 17

32MB Memory Upgrade Steps

2-5

Only use the special key provided if you have difficulty in removing the switch module.

Place the switch module on a grounded surface or antistatic bag with all components facing up.

Step 2 ￿Removing the 16MB Memory SIMM

The memory SIMM is located on the lower left corner of the module when the front panel is facing you. (Figure 2-5) On the top of the memory SIMM there are two metal spring clips (one on each side of

￿￿￿￿￿￿the SIMM) that hold the SIMM in place (Figure 2-6).

16MB Memory SIMM

Front Panel

Position of 16MB SIMM in CoreBuilder 7000HD Switch Module -

Front View

Page 16 Page 18
Image 17
Page 16 Page 18
Contents MB Memory Upgrade 3Com Corporation 5400 Bayfront Plaza Santa Clara, California Contents Page About this Guide Documentation ConventionsRelated User Guide Iv about this Guide Upgrade KIt InstallationIntroduction GeneralESD Safety Information Sicherheitsinformationen für elektrostatische Entladungen Information sur la prévention de décharges électrostatiques32MB Memory Upgrade SimmInstallation on 32MB Memory Upgrade32MB Memory Upgrade Steps Module Loosening the Captive Screws 32MB Memory Upgrade Steps Raise the key and slide the switch module out Figure Removing the 16MB Memory Simm Metal Spring Clip Side View of the Memory Simm Inserting the 32MB Memory Simm Cutout Inserting the 32MB Memory Simm Verifying 32MB Memory UpgradePage Numbers IndexVerifying memory upgrade Who should use this guide
Top Page Image Contents