3Com 7000HD manual Inserting the 32MB Memory Simm

Page 19

32MB Memory Upgrade Steps

2-7

Removing the 16MB SIMM at a 45 Degree Angle

Step 3 Inserting the 32MB Memory SIMM

Remove the 32MB Memory SIMM from the packaging material.

Make sure that the front panel of the switch module is facing you, and that the switch is on proper grounding material, or an antistatic bag.

Make sure that you hold the SIMM as follows:

The cutout on the gold connector edge is facing the front panel

(Figure 1-2).

The SIMM is held at a 45 degree angle.

Insert the SIMM with its gold connector into the black connector at a 45 degree angle (Figure 2-9).

Image 19

Contents MB Memory Upgrade 3Com Corporation 5400 Bayfront Plaza Santa Clara, California Contents Page About this Guide Related ConventionsDocumentation User Guide Iv about this Guide General InstallationUpgrade KIt IntroductionESD Safety Information Sicherheitsinformationen für elektrostatische Entladungen Information sur la prévention de décharges électrostatiques32MB Memory Upgrade SimmModule 32MB Memory UpgradeInstallation on 32MB Memory Upgrade StepsLoosening the Captive Screws 32MB Memory Upgrade Steps Raise the key and slide the switch module out Figure Removing the 16MB Memory Simm Metal Spring Clip Side View of the Memory Simm Inserting the 32MB Memory Simm Cutout Inserting the 32MB Memory Simm Verifying 32MB Memory UpgradePage Numbers IndexVerifying memory upgrade Who should use this guide