Rosewill RNX-N300X user manual National Restrictions

Page 2

Wireless LAN PCI Card RNX-N300X

User Manual

 

 

 

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

National Restrictions

2

Image 2
Contents Wireless LAN PCI Card RNX-N300X National Restrictions 2400.0-2483.5 MHz Country Restriction Table of Content Package Content Overview of the ProductFeatures LED StatusHardware Installation Software InstallationWireless LAN PCI Card RNX-N300X Wireless LAN PCI Card RNX-N300X Wireless LAN PCI Card RNX-N300X Configures a Basic Network Connection Management GuideIntroduction to the Wireless LAN Utility for Windows XP InterfacesStatus Information Profile Ssid Power Save ModeProfile Name RTS Threshold802.1x Authentication TypeEncryption Type WPA Pre-shared KeyID \ Password Client CertificationEAP Fast Server CertificationNetwork Advanced Statistics7 WMM Direct Link Setup Enable WMM EnableWMM Power Save Enable 8 WPSInformation Config ModeWPS AP List PIN CodePBC Introduction to the configuration utility for Windows VistaPIN Editing profile Link StatusDeleting profile Activating profileSite Survey Noise LevelBssid SignalStatistic Phy TypeWPS Configuration Re-scanning WPS AP InformationUUID-E PBC Method Configure WPS profilesPIN Method Manage WPS profilesAP mode management guide ConfigurationIsrael CH3 ~ CH9 Group Rekey Interval Security SettingAccess Control MAC Table AIDEvent Log StatisticsCTS RTS frame