WPS AP List, Information, PIN Code, Detail

Wireless LAN PCI Card RNX-N300X		User Manual

WPS AP List	Display the information of surrounding APs with WPS IE from
	last scan result. List information includes SSID, BSSID,
	Channel, ID (Device Password ID), Security-Enabled.
Rescan	Click to rescan the wireless networks.
Information	Display the information about WPS IE on the selected network.
	List information includes Authentication Type, Encryption Type,
	Config Methods, Device Password ID, Selected Registrar,
	State, Version, AP Setup Locked, UUID-E and RF Bands.
PIN Code	8-digit numbers. It is required to enter PIN Code into Registrar
	using PIN method. Each Network card has only one PIN Code
	of Enrollee.
Config Mode	Enrollee or an external Registrar.
Table of Credentials	Display all of credentials got from the Registrar. List information
	includes SSID, MAC Address, Authentication and Encryption
	Type. If STA Enrollee, credentials are created as soon as each
	WPS success. If STA Registrar, RaUI creates a new credential
	with WPA2-PSK/AES/64Hex-Key and doesn't change until next
	switching to STA Registrar.
Detail	Information about Security and Key in the credential.
Connect	Command to connect to the selected network inside
	credentials.
Rotate	Command connect to the next network inside credentials
Disconnect	Stop WPS action and disconnect this active link. And then
	select the last profile at the Profile Page of RaUI if exist. If there
	is an empty profile page, the driver will select any non-secure
	AP

WPS AP List