SUPER MICRO Computer MIIC-203 manual Diagnostic Set-up iPort Only

Page 25

Diagnostic Set Up Screen

Diagnostic Set-up (iPort Only)

On the Diagnostic Set-up screen you can set the following parameters:

1.iPort Log File Level

Select iPort logging level.1 gives minimal info, 4 is verbose. Use the log file to troubleshoot communication problems.

2.Log File Name

iPort log file name if enabled.

3. Log File Size (Lines)

iPort log file length if enabled.

4. Set the Destination Slave Address

On the main screen, use the I2C Destination Address list control to set the slave address of the device you want to communicate with.

Additional operating information is available by viewing the Status and Log File. (Option available only for the iPort).

26

Image 25

Contents 479,12 Introduction Page Table of Contents Programmer’s Reference Ascii Command Interface Definitions Page Model MIIC-203 PartOverview RS-232 to I2C Host Adapter Ascii Fast Mode InterfaceSystem Requirements RS-232 Serial Port ConnectorInterconnects Packing SlipDB-25 Serial Port Pinout +5VDC Power JackINT, Interrupt Signal Control I2C Interface ConnectorConnecting to an SMBus System Connecting to a 3.3v SystemHardware Set-Up Pull-up ResistorsIPort Utility Pack for Windows Introduction to Utility Pack IPort Message CenterIPort Message Manager Software Installation Page I2C Message Operations Page Page Page Select iPort Device Starting the programEstablish iPort Link Basic Set-up Advanced Set-up Diagnostic Set-up iPort Only To Master Transmit Data Sending Messages Master OperationsTo Master Receive Data To Slave Transmit a message Uninstalling iPort Utility PackTo Slave Receive a message Programmer’s Reference IPort/AFM Quick Start Command Description IPort/AFM Ascii Text Interface CommandsSynchronous Interface Events IPort/AFM ResetRS-232 Baud Rate Status DisplaySet Destination I2C Slave Address Close I2C ConnectionEcho/Prompt Control Flow ControlHex Only Display Control I2C General Call ControlSet iPort/AFM’s Own I2C Slave Address Command Menu DisplayI2C Bus Clock Rate Control Open I2C Connection Interrupt Signal Control/StatusMaster Read Message Slave Transmit Message Master Transmit Message Set I2C Bus Time-oUt in msec EXtended Commands requires V2.00+Display Firmware Version requires V2.00+ Page Issue a Read WCR command to a Xicor X9241 at slave address Display Tx bYte Count requires V2.00+ Slave Transmit Request Asynchronous Interface EventsSlave Receive Complete General Call Receive CompleteINterrupt Signal Release INterrupt Signal AssertI2C Bus Time-out Detected IPort/AFM Prompts I2C Bus Error DetectedIPort/AFM Ready Slave Not AcknowledgingInvalid iPort/AFM Command Invalid Command ArgumentIPort/AFM Connection Closed Slave Transmit Request Not ActiveIPort/AFM Initialization Example CodeMaster Receive Message Communication Event ProcessingPage Page Page Revision IPort/AFM Revision ReportAdditional Information Micro Computer Control CorporationLife Support Applications Limited WarrantyLimitation of Remedies and Damages Appendix a