SUPER MICRO Computer MIIC-203 manual IPort/AFM Ascii Text Interface Commands, Command Description

iPort/AFM

ASCII Text Interface Commands

Note: [CR] = Carriage Return Code or Enter Key.

Syntax: [Select], (Optional), xx = [00..FE], n = [0..32767]

Command	Description
Ctrl/R,Ctrl/R,Ctrl/R	iPort/AFM Reset
	This command resets the iPort/AFM to its default state.
//[CR]	Status Display
	Display iPort/AFM status information.
/B[012][CR]	RS-232 Baud Rate Control
	Set the RS-232 Baud rate (0 = 19.2, 1 = 57.6, 2 = 115.2 Baud)
/C[CR]	Close I2C Connection
	Disconnect from the I2C Bus.
/Dxx[CR]	Set Destination I2C Slave Address
	Set the destination I2C Slave Address for subsequent Master Transmit or
	Receive operations.
/E[01][CR]	Echo/Prompt Control [0 = Disable, 1 = Enable]
	Enable/Disable data entry echo and prompts.
/F[01][CR]	Flow Control [0 = XON/XOFF, 1 = RTS/CTS]
	Select serial communication handshaking protocol.
/G[01][CR]	I2C General Call Control [0 = Disable, 1 = Enable]
	Enables/Disables iPort/AFM response to I2C Bus General Call (00)
	messages.
/H[01][CR]	Hex Only Display Control [0 = Disable, 1 = Enable]
	Controls display format of received message data.
/Ixx[CR]	Set iPort/AFM’s Own I2C Slave Address
	Sets iPort/AFM's own I2C Slave Address. iPort/AFM will respond to I2C
	Bus messages sent to this address.
/K[0123][CR]	I2C Bus Clock Rate Control
	Set I2C Bus Clock Rate Control (0=23, 1=86, 2=100, 3=400 KHz)
/M[CR]	Command Menu Display
	Display iPort/AFM's Command Menu

32