SUPER MICRO Computer MIIC-203 manual Limitation of Remedies and Damages

Page 55

implied, included but not limited to the implied warranties of merchantability and fitness for a particular purpose. The Purchaser assumes entire risk as it applies to the quality and performance of the Software. Should the Software prove defective, the Purchaser (and not MCC, authorized MCC distributors, or dealers) assume the entire cost of all necessary servicing, repair or correction.

Limitation of Remedies and Damages

MCC's entire liability and remedy will be the replacement of any disks not meeting MCC "Limited Warranty" explained above.

In no event will MCC be liable for any damages direct, indirect, incidental, or consequential, including damages for lost profits, lost savings, or other incidental or consequential damage arising out of the use or inability to use such Software, even if MCC has been advised of the possibility of such damages or for any claim by any other party. In no event will MCC's liability of damages to the Purchaser or any other person ever exceed the amount of the license fee paid by the Purchaser to use the Software regardless of the form of the claim.

This Agreement is governed by the laws of the State of New Jersey USA (except federal law governs copyrights and registered trademarks.) If a provision of this Agreement is deemed invalid by any court having jurisdiction, that particular provision will be deemed deleted and will not affect the validity of any other provision of this Agreement.

TEL(609)466-1751 FAX (609)466-4116 EMAIL info@mcc-us.com

For the latest product information, application notes, and free software updates

visit our Web Site at:

http://www.mcc-us.com

56

Image 55
Contents 479,12 Introduction Page Table of Contents Programmer’s Reference Ascii Command Interface Definitions Page Model MIIC-203 PartOverview RS-232 to I2C Host Adapter Ascii Fast Mode InterfacePacking Slip RS-232 Serial Port ConnectorSystem Requirements InterconnectsDB-25 Serial Port Pinout +5VDC Power JackINT, Interrupt Signal Control I2C Interface ConnectorPull-up Resistors Connecting to a 3.3v SystemConnecting to an SMBus System Hardware Set-UpIPort Utility Pack for Windows Introduction to Utility Pack IPort Message CenterIPort Message Manager Software Installation Page I2C Message Operations Page Page Page Select iPort Device Starting the programEstablish iPort Link Basic Set-up Advanced Set-up Diagnostic Set-up iPort Only To Master Transmit Data Sending Messages Master OperationsTo Master Receive Data To Slave Transmit a message Uninstalling iPort Utility PackTo Slave Receive a message Programmer’s Reference IPort/AFM Quick Start Command Description IPort/AFM Ascii Text Interface CommandsSynchronous Interface Events IPort/AFM ResetRS-232 Baud Rate Status DisplayFlow Control Close I2C ConnectionSet Destination I2C Slave Address Echo/Prompt ControlHex Only Display Control I2C General Call ControlSet iPort/AFM’s Own I2C Slave Address Command Menu DisplayI2C Bus Clock Rate Control Open I2C Connection Interrupt Signal Control/StatusMaster Read Message Slave Transmit Message Master Transmit Message Set I2C Bus Time-oUt in msec EXtended Commands requires V2.00+Display Firmware Version requires V2.00+ Page Issue a Read WCR command to a Xicor X9241 at slave address Display Tx bYte Count requires V2.00+ General Call Receive Complete Asynchronous Interface EventsSlave Transmit Request Slave Receive CompleteINterrupt Signal Release INterrupt Signal AssertI2C Bus Time-out Detected Slave Not Acknowledging I2C Bus Error DetectedIPort/AFM Prompts IPort/AFM ReadySlave Transmit Request Not Active Invalid Command ArgumentInvalid iPort/AFM Command IPort/AFM Connection ClosedCommunication Event Processing Example CodeIPort/AFM Initialization Master Receive MessagePage Page Page Micro Computer Control Corporation IPort/AFM Revision ReportRevision Additional InformationLife Support Applications Limited WarrantyLimitation of Remedies and Damages Appendix a