SUPER MICRO Computer MIIC-203 manual Uninstalling iPort Utility Pack, To Slave Transmit a message

Page 28

Slave Operations

To Slave Transmit a message:

Enter data to be transmitted in the Slave Tx Message Bytes control by single clicking. Binary data bytes are entered using a three character Hex-Equivalent format (~00 ... ~FF), you may also type in ASCII text. These bytes are automatically transmitted when a Slave Transmit Request is received from a Master device.

To Slave Receive a message:

Data bytes received from a Master Transmitter are automatically displayed in the Received Message window. Received binary data is displayed using a three character Hex-Equivalent format (~00 ... ~FF). By selecting the Hex- Display checkbox, the data is displayed as Hexadecimal data .

Uninstalling iPort Utility Pack

Click, Start Programs iPort Utility Pack uninstall.

Follow the on screen instructions.

29

Image 28
Contents 479,12 Introduction Page Table of Contents Programmer’s Reference Ascii Command Interface Definitions Page Part Model MIIC-203RS-232 to I2C Host Adapter Ascii Fast Mode Interface OverviewRS-232 Serial Port Connector System RequirementsInterconnects Packing Slip+5VDC Power Jack DB-25 Serial Port PinoutI2C Interface Connector INT, Interrupt Signal ControlConnecting to a 3.3v System Connecting to an SMBus SystemHardware Set-Up Pull-up ResistorsIPort Utility Pack for Windows IPort Message Center Introduction to Utility PackIPort Message Manager Software Installation Page I2C Message Operations Page Page Page Select iPort Device Starting the programEstablish iPort Link Basic Set-up Advanced Set-up Diagnostic Set-up iPort Only Sending Messages Master Operations To Master Transmit DataTo Master Receive Data To Slave Transmit a message Uninstalling iPort Utility PackTo Slave Receive a message Programmer’s Reference IPort/AFM Quick Start IPort/AFM Ascii Text Interface Commands Command DescriptionIPort/AFM Reset Synchronous Interface EventsStatus Display RS-232 Baud RateClose I2C Connection Set Destination I2C Slave AddressEcho/Prompt Control Flow ControlI2C General Call Control Hex Only Display ControlSet iPort/AFM’s Own I2C Slave Address Command Menu DisplayI2C Bus Clock Rate Control Interrupt Signal Control/Status Open I2C ConnectionMaster Read Message Slave Transmit Message Master Transmit Message Set I2C Bus Time-oUt in msec EXtended Commands requires V2.00+Display Firmware Version requires V2.00+ Page Issue a Read WCR command to a Xicor X9241 at slave address Display Tx bYte Count requires V2.00+ Asynchronous Interface Events Slave Transmit RequestSlave Receive Complete General Call Receive CompleteINterrupt Signal Release INterrupt Signal AssertI2C Bus Time-out Detected I2C Bus Error Detected IPort/AFM PromptsIPort/AFM Ready Slave Not AcknowledgingInvalid Command Argument Invalid iPort/AFM CommandIPort/AFM Connection Closed Slave Transmit Request Not ActiveExample Code IPort/AFM InitializationMaster Receive Message Communication Event ProcessingPage Page Page IPort/AFM Revision Report RevisionAdditional Information Micro Computer Control CorporationLimited Warranty Life Support ApplicationsLimitation of Remedies and Damages Appendix a