SUPER MICRO Computer MIIC-203 manual System Requirements, Interconnects, Packing Slip

Page 9

Packing Slip

This package includes the following items:

•iPort/AFM (#MIIC-203) RS-232 to I2C Host Adapter with ASCII Fast Mode Interface.

•4 Foot I2C Interface Cable. (#CAB4)

•1Ft. /INT-Trigger Cable (#AXM-12G)

•Serial Port Cable, 9F/25M, 1 Foot Long. (#C9F25M1)

•1Ft. /INT-Trigger Cable (#AXM-12G)

•iPort/AFM User’s Guide.

•iPort Utility Pack for Windows Software.

•Power Supply

Standard 120VAC, 60Hz, USA Plug (#MWT-5VA) European 220VAC, 50Hz, European Plug (#MWT-5VAE)

International 120/220/240VAC, 50-60Hz, Int.Plug selection (#MWT-5VAI)

System Requirements

a. Host computer

b. 1 free RS-232 Serial Port

Interconnects

The I2C Bus Host Adapter includes four interconnections:

1. RS-232 Serial Port Connector

RS-232 Serial Port Connector

This connector provides connection

to the serial port on the PC. Use the #C9F25M1 cable to adapt the iPort to 9-pin serial ports.

10

Image 9

Contents 479,12 Introduction Page Table of Contents Programmer’s Reference Ascii Command Interface Definitions Page Model MIIC-203 PartOverview RS-232 to I2C Host Adapter Ascii Fast Mode InterfaceSystem Requirements RS-232 Serial Port ConnectorInterconnects Packing SlipDB-25 Serial Port Pinout +5VDC Power JackINT, Interrupt Signal Control I2C Interface ConnectorConnecting to an SMBus System Connecting to a 3.3v SystemHardware Set-Up Pull-up ResistorsIPort Utility Pack for Windows Introduction to Utility Pack IPort Message CenterIPort Message Manager Software Installation Page I2C Message Operations Page Page Page Starting the program Select iPort DeviceEstablish iPort Link Basic Set-up Advanced Set-up Diagnostic Set-up iPort Only To Master Transmit Data Sending Messages Master OperationsTo Master Receive Data Uninstalling iPort Utility Pack To Slave Transmit a messageTo Slave Receive a message Programmer’s Reference IPort/AFM Quick Start Command Description IPort/AFM Ascii Text Interface CommandsSynchronous Interface Events IPort/AFM ResetRS-232 Baud Rate Status DisplaySet Destination I2C Slave Address Close I2C ConnectionEcho/Prompt Control Flow ControlHex Only Display Control I2C General Call ControlCommand Menu Display Set iPort/AFM’s Own I2C Slave AddressI2C Bus Clock Rate Control Open I2C Connection Interrupt Signal Control/StatusMaster Read Message Slave Transmit Message Master Transmit Message EXtended Commands requires V2.00+ Set I2C Bus Time-oUt in msecDisplay Firmware Version requires V2.00+ Page Issue a Read WCR command to a Xicor X9241 at slave address Display Tx bYte Count requires V2.00+ Slave Transmit Request Asynchronous Interface EventsSlave Receive Complete General Call Receive CompleteINterrupt Signal Assert INterrupt Signal ReleaseI2C Bus Time-out Detected IPort/AFM Prompts I2C Bus Error DetectedIPort/AFM Ready Slave Not AcknowledgingInvalid iPort/AFM Command Invalid Command ArgumentIPort/AFM Connection Closed Slave Transmit Request Not ActiveIPort/AFM Initialization Example CodeMaster Receive Message Communication Event ProcessingPage Page Page Revision IPort/AFM Revision ReportAdditional Information Micro Computer Control CorporationLife Support Applications Limited WarrantyLimitation of Remedies and Damages Appendix a