Chapter 2
System Safety
2-1 Electrical Safety Precautions
Basic electrical safety precautions should be followed to protect yourself from harm and the SuperBlade from damage:
•Be aware of how to power on/off the enclosure power supplies and the individual blades as well as the room's emergency
•Do not work alone when working with high voltage components.
•Power should always be disconnected from the blade module when removing or installing such system components as the mainboard, memory modules and processors.
•When working around exposed electrical circuits, another person who is familiar with the
•Use only one hand when working with
•Do not use mats designed to decrease electrostatic discharge as protection from electrical shock. Instead, use rubber mats that have been specifically designed as electrical insulators.
•The power supply power cords must include a grounding plug and L line. It must be plugged into grounded electrical outlets. Power input requires
•Mainboard Battery: This battery must be replaced only with the same or an equivalent type recommended by the manufacturer (CR2032 Lithium 3V battery). Dispose of used batteries according to the manufacturer's instructions.
WARNING: There is a danger of explosion if the onboard battery is installed upside down, which will reverse its polarities.
WARNING: Please handle used batteries carefully. Do not damage the battery in any way; a damaged battery may release hazardous materials into the environment. Do not discard a used battery in the garbage or a public landfill. Please comply with the regulations set up by your local hazardous waste management agency to dispose of your used battery properly.
•Mainboard replaceable