SUPER MICRO Computer SBI-7226T-T2 Chapter Setup and Installation, Installing Blade Modules

Chapter 3

Setup and Installation

3-1 Overview

This chapter covers the setup and installation of the blade module and its components.

3-2 Installing Blade Modules

Up to ten SBI-7226T-T2 blade modules may be installed into a single blade enclosure (depending upon your enclosure and blade). Blade modules with Windows and Linux operating systems may be mixed together in the same blade enclosure.

Powering Up a Blade Unit

Each blade unit may be powered on and off independently from the rest of the blades installed in the same enclosure. A blade unit may be powered up in two ways:

•Press the power button on the blade unit.

•Use IPMIView or the web-browser based management utility to apply power using either a CMM module, or by the use of the onboard BMC chip in the blade module.

Powering Down a Blade Unit

A blade unit may be powered down in either of five ways:

•Press the power button on the blade unit.

•Use IPMIView or the web-browser based management utility to power down (if you have Operator or Admin privileges on the CMM).

•Use SuperBladeTool when connected to the CMM to power down (if you have Operator or Admin privileges on the CMM).

•Use IPMIview or a browser connected to the onboard BMC chip to power down.

•Use SuperBladeTool to use a Command Line Interface (CLI) to the onboard BMC chip, if you have Operator or Admin privileges.

Removing a Blade Unit from the Enclosure

Although the blade system may continue to run, individual blades should always be powered down before removing them from the enclosure.

Removing a Blade Unit from the Enclosure

1.Power down the blade unit (see "Powering Down a Blade Unit" above).

2.Squeeze both handles to depress the red sections then pull out both handles completely and use them to pull the blade unit from the enclosure.

3-1