SUPER MICRO Computer 1022G-URF user manual Control Panel, System Fans

A+ SERVER 1022G-URF User's Manual

Figure 6-1. Chassis: Front and Rear Views

Slim DVD-ROM Drive System LEDs Control Panel

Hard Drive Bays System Reset Main Power

Power Supply Modules USB Ports PCI Expansion Slots (w/ Riser Cards)

Mouse/Keyboard Ports COM1 Port VGA Port Ethernet Ports

Note: the SC815TQ-560UBP chassis (6016T-UF/6016T-NTF) has only a single power supply module.

6-2 Control Panel

The control panel (located on the front of the chassis) must be connected to the JF1 connector on the serverboard to provide you with system status indications. These wires have been bundled together as a ribbon cable to simplify the connection.

Connect the cable from JF1 on the serverboard to the appropriate header on the Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both connectors. Pull all excess cabling out of the airflow path.

The control panel LEDs inform you of system status. See "Chapter 3: System Interface" for details on the LEDs and the control panel buttons. Details on JF1 can be found in "Chapter 5: Advanced Serverboard Setup."

6-3 System Fans

Four 4-cm heavy duty counter-rotating fans provide the cooling for the A+ SERVER 1022G-URF. Each fan unit is actually made up of two fans joined back- to-back, which rotate in opposite directions. This counter-rotating action generates exceptional airflow and works to dampen vibration levels. It is very important that the chassis top cover is properly installed and making a good seal in order for the cooling air to circulate properly through the chassis and cool the components. See Figure 6-2.

6-2