Installation Manual | IMN |
TigerAccess™ EE |
|
|
|
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15/68 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a par- ticular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is en- couraged to try to correct the interference by one or more of the following measures:
−Reorient or relocate the receiving antenna
−Increase the separation between the equipment and receiver
−Connect the equipment into an outlet on a circuit different from that to which the receiver in connected.
−Consult the dealer or an experienced radio/TV technician for help.
1.10UL Safety Compliance
This switch has been tested and found to comply with the requirements of UL. This equipment is intended to be powered from a limited power source output of a previously certified power supply.
1.11Declaration of RoHS Conformity
SMC Networks considers the protection of the environment and the preservation of natu- ral resources as a major duty and thus undertakes great efforts to design its products to be environmental friendly.
Therefore, as of July 1st, 2006, all contract products of SMC Networks
•to which the RoHS (the Restriction on the use of certain Hazardous Substances in electrical and electronic equipment) directive applies to
•and which are put on the market within the countries where the RoHS requirements are transposed into national law
are in compliance with the requirements of the RoHS.
SMC Networks reserves the right to apply the exemptions to the RoHS requirements as set out in the Annex to the RoHS directive, in particular lead in solders for network infra- structure equipment for switching, signaling, transmission as well as network manage- ment for telecommunication.
SMC7824M/VSW | 11 |