SMC Networks 10/100 Mbps manual Hardware Description

Page 13

HARDWARE DESCRIPTION

Hardware Description

The Fast Ethernet PCI is equipped with:

•1 RJ-45 connector for 10/100 Mbps connections

•1 3-pin connector for Wake-On-LAN cable

•1 Socket for optional boot ROM

•1 LED indicator

The components of the Fast Ethernet PCI are shown in the figure below:

Optional Boot ROM Socket

LED Indicator

RJ-45 Connector for 10/100 Mbps

Wake-On-LAN Connector

3

Image 13

Contents Fast Ethernet PCI Page Fast Ethernet PCI User Guide Trademarks CopyrightLimited Warranty Limited Warranty FCC Class B CompliancesVcci Class B Compliance Japan EC Conformance Declaration Class B Table of Contents Specifications Cable SpecificationsAbout Fast Ethernet PCIFeatures and Benefits Hardware Description RJ-45 LED IndicatorsRemote LAN Wakeup Equipment Checklist InstallationHardware Installation Installation Driver Installation Click Next Check Specify a location, and click Next Driver Installation Installation Software Installation Page Page Installation EtherGuard Installation Page Installation Page Installation WiNeTool Configuration TX/RX Information ConfigurationSend Packet Packet Generator Send Acpi Packet ON/OFF Receive Packet GuageCapture Console Toolbar Filter Setting MAC Address Filter Setting Protocol Filter Setting IP AddressFilter Setting Buffer Size Filter Setting PatternPacket Analysis Receive Packet Detail PCI Compatibility TroubleshootingTroubleshooting Network Card Installation Problems Solutions for Common ProblemsNetwork Connection Problems Cable and Specifications Cable SpecificationsTwisted-Pair Cable and Pin Assignments RJ-45 Pin Assignments Specifications Compliances WarrantyNetWare ODI Drivers Unix DriversPage For Technical SUPPORT, Call