SMC Networks 10/100 Mbps manual Installation

Page 26

INSTALLATION

7.Choose the location where the program icons will be located and click “Next”.

8.Check the “To launch EtherGuard” box and click “Finish” to complete the installation and launch the EtherGuard program.

The EtherGuard program may also be started by clicking “Start/ Programs/EtherGuard/Etherguard”. The program will start and then run in the background. A globe icon will appear on the toolbar (see the figure on the next page). Double-click the icon to bring the program to the foreground.

See the following section for EtherGuard configuration instructions, or go to “WiNeTool” on page 23 for WiNeTool configuration instructions.

16

Image 26

Contents Fast Ethernet PCI Page Fast Ethernet PCI User Guide Copyright TrademarksLimited Warranty Limited Warranty Vcci Class B Compliance Japan CompliancesFCC Class B EC Conformance Declaration Class B Table of Contents Cable Specifications SpecificationsFast Ethernet PCI AboutFeatures and Benefits Hardware Description LED Indicators RJ-45Remote LAN Wakeup Installation Equipment ChecklistHardware Installation Installation Driver Installation Click Next Check Specify a location, and click Next Driver Installation Installation Software Installation Page Page Installation EtherGuard Installation Page Installation Page Installation WiNeTool Configuration Configuration TX/RX InformationSend Packet Packet Generator Send Acpi Packet Receive Packet Guage ON/OFFCapture Console Toolbar Filter Setting MAC Address Filter Setting IP Address Filter Setting ProtocolFilter Setting Pattern Filter Setting Buffer SizePacket Analysis Receive Packet Detail Troubleshooting PCI CompatibilityTroubleshooting Solutions for Common Problems Network Card Installation ProblemsNetwork Connection Problems Twisted-Pair Cable and Pin Assignments Cable SpecificationsCable and Specifications RJ-45 Pin Assignments Specifications NetWare ODI Drivers WarrantyCompliances Unix DriversPage For Technical SUPPORT, Call