SMC Networks SMC2582W-B manual Resetting Configuration to Factory Defaults

Page 31

3.3.3.5. Resetting Configuration to Factory Defaults

Fig. 32. Configuration reset.

Clicking the Reset button resets the device configuration to factory defaults.

WARNING: Think twice before clicking the Reset button.You’ll lose all your current configuration settings.

3.4.Configuring TCP/IP Related Settings

3.4.1.Addressing

Fig. 33.TCP/IP settings.

The IP address of the SMC2582W-B can be manually set (Set Manually) or automatically assigned by a DHCP server on the LAN (Obtain from a DHCP Server). If you are manually setting the IP address, Subnet mask, and Default gateway settings, set them appropriately, so that they comply with your LAN environment. In addition, you can specify the Host name and Domain (DNS suffix) of the SMC2582W-B.

31

Image 31

Contents C 2 5 8 2 W B Trademarks CopyrightTesla FCC Radiation Exposure Statement Federal Communication Commission Interference StatementIndustry Canada Class B Wichtige Sicherheitshinweise Germany EC Conformance Declaration Class BEdificio Conata Page Introduction Features Ieee 802.11b Operational modesOverview Page Management LED Definitions To power outlet To power the SMC2582W-B by SMCPWR-INJ3 Power InjectorHang the SMC2582W-B on the screws Mounting the SMC2582W-B on a WallMounting the SMC2582W-B on a wall Preparing for ConfigurationChanging the TCP/IP Settings of the Managing Computer Entering the User Name and Password Configuring the SMC2582W-BStart Selecting an Operational ModeLowing table Operational modes vs. wireless link types Configuring Ieee 802.11 Settings Configuring TCP/IP SettingsSelect the corresponding Enabled check box Wireless Distribution System settings To enable a WDS linkSettings changes are highlighted in red Reviewing and Applying SettingsFix the alignment of the antenna on one side Deploying the SMC2582W-BOverview Using Web-Based ManagementMenu Structure Advanced. Advanced settings of the SMC2582W-B Save, Save & Restart, and Cancel CommandsManagement. UPnP, System Log, and Snmp settings Viewing Status Associated Wireless Clients Home and Refresh CommandsSystem Log Current Dhcp MappingsGeneral Operations Selecting an Operational Mode Managing Firmware Changing PasswordUpgrading Firmware by Http Configuration restore by HttpChoose Tftp as the Firmware management protocol To restore configuration of the SMC2582W-B by HttpTrigger the firmware upgrade process by clicking Upgrade Upgrading Firmware by TftpBacking up and Restoring Configuration Settings by Tftp Choose Tftp as the Firmware management protocol Configuring TCP/IP Related Settings Addressing Resetting Configuration to Factory DefaultsStatic Dhcp Mappings Dhcp Server BasicBasic Ieee 802.11b communication settings Link Integrity Wireless Distribution SystemWireless Distribution System settings To enable a WDS link Network topology containing a loop SecurityPage MAC-address-based access control settings MAC-Address-Based Access ControlClick Download MAC ACL download settingsEthernet Type Filters Configuring Advanced Settings Packet FiltersIP Protocol Filters Management Basic TCP/UDP Port FiltersUPnP Snmp System log settingsPage Appendix a Default Settings Check the following first Appendix B TroubleshootingWireless Settings Problems TCP/IP Settings ProblemsPage SMC2582W-B Configuration Utility Other ProblemsContact our technical support representatives for repair Distances and Data RatesPage Syslog Event Logging LEDs Power Configuration and Management Web-browser TelnetWeight 80 lbs Storage Humidity SMCPWR-INJ3 Power InjectorStorage Temperature Pin Assignments and Polarity + 4/5 7/8 Output VoltageFor Technical SUPPORT, Call

Related manuals

Manual 2 pages 61.05 Kb