Terminal Side of Switch

3.Solder the conductors to the switch terminals to ob- tain the desired function (see Figure 3 for switch configuration.) Take care no to leave long bare con- ductors that may bridge across terminals and make unintended connections.

NOTE: When the switch is used to make connections in the middle of a cable run, It is very important to preserve continuity in the cable shield. If a splice is necessary for this, be sure it is insulated from other terminals, or you may employ an unused switch terminal to make the con- nection. Leaving the shield discontinuous may cause undesirable hum in a circuit.

FIGURE 3

4.Assemble the switch by inserting the tab on the bot- tom back of the switch into the slot in the upper case front. (See Figure 4)

5.Insert the flange in the flex relief into the slot be- tween the case bottom and the small horizontal pro- jection.

6.If the strain relief is used, align its hole with the hole in the center boss in the lower case front. Align the cable to one side of the boss.

NOTE: If the cable is knotted to provide a strain relief, the center boss in the case may be inserted through the center of the knot with the cable lying to the side of the boss.

ASSEMBLING THE SWITCH

FIGURE 4

7.Use the three provided thread-forming screws to fasten the case back to the case front, making sure not to pinch any leads. (If the strain relief is used, make certain that it is captured by the screw through the lower center back of the case.)

SHURE Incorporated Web Address: http://www.shure.com 5800 W. Touhy Avenue, Niles, IL 60714–4608, U.S.A. Phone: 800-257–4873 Fax: 847-866-2279

In Europe, Phone: 49-7131-72140 Fax: 49-7131-721414

In Asia, Phone: 852-2893-4290 Fax: 852-2893-4055

Elsewhere, Phone: 847-866–2200 Fax: 847-866-2585