Digital Coaxial DIG Coax, Digital Optical Optical

Digital Coaxial (DIG COAX)

Use a Digital Coaxial cable to connect an audio source with a Digital Coaxial output to the D5RH’s Source Input as shown in Figure 3.2. NOTE: Make sure to put the COAX/OPT switch in the COAX (up) position. Digital Connections provide the best audio quality and should be used if available. If both a Digital Coaxial connection and a Digital Optical connection are present on the audio source, use only one. DO NOT connect both Coaxial and Optical outputs to the D5RH.

D5RH

Digital

Coax

Digital SourceCable

Digital Output

SPDIF

Figure 3.2: Source Input – Digital Coaxial

Digital Optical (OPTICAL)

Use a Digital Optical (TOSLINK) cable to connect an audio source with a Digital Optical output to the D5RH’s Source Input as shown in Figure 3.3. NOTE: Make sure to put the COAX/OPT switch in the OPT (down) position. Digital Connections provide the best audio quality and should be used if available. If both a Digital Coaxial connection and a Digital Optical connection are present on the audio source, use only one. DO NOT connect both coaxial and optical outputs to the D5RH.

D5RH

Digital
Optical
Cable	Audio Source
	Digital Optical
	Output
	DIGITAL
	OPTICAL

Figure 3.3: Source Input – Digital Optical

NOTE: Multi-channel digital audio formats (5.1, 7.1 etc.) are not supported by the D5IP and D5RH. However, many audio/video sources allow you to change the digital output to PCM Stereo. In most cases this will allow multi-channel audio sources to output a “summed” stereo signal through the digital output. Consult the audio/video source manual for details.

NOTE: Some audio sources which utilize a digital output require that you enable the digital output before it will function. If there is no audio present, check the setup menu of the audio source to confirm that the digital output is enabled.


08905153B	- 15 -