Xantech D5RH installation instructions D5IP Source Input Wall Plate

Page 23

D5IP Source Input Wall Plate

A D5IP Source Input Wall Plate is required to add a Local Source to a zone. The wall plate has audio and IR connections similar to the SOURCE INPUT of the D5RH. A run of CAT-5 terminated to T- 568A standard (see Figure 2.2) is required between the D5KP Amplified Keypad and the location designated for the D5IP. Connections between a source component and the D5IP are detailed in Figure 3.10 to Figure 3.12, while connections between the D5IP and the D5KP Amplified Keypad are detailed in Figure 3.15. NOTE: Set RCA/OPT/COAX switch to RCA (up) position.


08905153B	- 23 -

Image 23

Contents Installation Instructions Safety Information Important Safety InformationOperating Temperatures & Environments Introduction D5RH Accessories FeaturesSource Defining TermsFront Panel ZoneRear Panel Connector FunctionPlanning System Design Overview/ApplicationsPre-Construction Retro-Fit Wiring/ Post ConstructionLocal Sources to Amplifier Keypad Pre-WiringAmplifier Keypad to Speakers Basic 4 Zone, 4 Source System ApplicationsSpeakers D5IP CAT Source Expanded System 4 Sources / 10 Zones + Local Sources D5XH Expansion RouterAnalog ConnectionsSource Audio Inputs Digital Optical Optical Digital Coaxial DIG CoaxSource Loop Outputs Source Loop Outputs Source Loop OUTExpansion OUT D5-NETIR Outputs IR OUT/ALL IR OUTZone OUT Connections Zone OUTSpeaker Connections D5KP Speaker ConnectionsAUX Power OUT Connections Auxiliary Power Connector AUX Power OUTLocal Sources AC Power ConnectorD5IP Source Input Wall Plate D5IP 14 IR Out to Source Connections IR OUT# of Chassis Max # of Zones Adding Zones D5XH Digital Audio Distribution HubSource Loop OUT/SOURCE Loop Expansion OUT/EXPANSIONAnalog Source Input Gain Settings & OperationDIP Switch Settings Zone PairingAudio Appendix a Specifications Xantech Limited Warranty