Dolby Pro Logic II Mode
You can select the desired Dolby Pro Logic II audio mode.
Press the 
PL II button.
| When listening to music, you can | |
MUSIC | experience sound effects as if you are | |
| listening to the actual performance. | |
|
| |
MOVIE | Adds realism to the movie soundtrack. | |
|
| |
| You can listen to a 2CH sound source | |
| in 5.1CH surround sound with all | |
PROLOG | speakers active. | |
| - A specific speaker(s) may not be | |
| output depending on the input signal. | |
|
| |
MATRIX | You will hear | |
sound. | ||
| ||
|
| |
| Select this to listen to sound from the | |
STEREO | front left and right speakers and the | |
| subwoofer only. | |
|
|
✎NOTE
`When selecting Pro Logic II mode, connect your external device to the AUDIO INPUT jacks (L and R) on the product. If you connect to only one of the inputs (L or R), you cannot listen to surround sound.
`The Pro Logic II function is only available in Stereo mode.
Listening to Radio
Using buttons on the Remote Control
1.Press the FUNCTION button to select FM.
2.Tune in to the desired station.
~Preset Tuning 1 : You must first add a desired frequency as a preset. Press the STOP (@) button to select PRESET and then press the TUNING/CH (
) button to select the preset station.
|
|
| 04 | |
~ Manual Tuning : Press the STOP (@) button to | Basic | |||
| ||||
select MANUAL and then press the TUNING/CH | Functions | |||
( | ) button to tune in to a lower or higher | |||
| ||||
frequency. |
|
| ||
~ Automatic Tuning : Press the STOP (@) button |
| |||
to select MANUAL and then press and hold the |
| |||
TUNING/CH ( | ) button to automatically |
| ||
search the band. |
|
| ||
Setting Mono/Stereo
Press the MO/ST button.
~Each time the button is pressed, the 
sound switches between STEREO and 
MONO.
~In a poor reception area, select MONO for a clear,
Presetting Stations
Example : Presetting FM 89.10 in the memory
1.Press the FUNCTION button to select FM.
2. Press the TUNING/CH (
) button to select <89.10>.
3.Press the TUNER MEMORY button.
~Number flashes on the display.
4. Press the TUNING/CH (
) buttons to select preset number.
~You can select between 1 and 15 presets.
5.Press the TUNER MEMORY button again.
~Press the TUNER MEMORY button before number disappears from the display.
~Number disappears from the display and the station is stored in memory.
6.To preset another station, repeat steps 2 to 5.
~To tune in to a preset station, press the TUNING/ CH (
) buttons on the remote control to select a channel.