Getting Started
Getting Started, cont.
First charge the battery in your AirPad, connect the power supply to the POWER jack on the side of your AirPad (not the headphone jack) and plug the power supply into an AC outlet. It may take up to 4 hours to fully charge the unit.
The plug does 
not go all the 
way in, this is
normal.
ON/OFF VOL - VOL+
POWER USB Reset HDMI out MicroSD card slot Headphones
The AirPad does NOT charge via the included USB cable.
For best battery performance leave your AirPad charging overnight or when not in use. See also page 21.
You can read various sections of this manual at any time to learn how to accomplish specific tasks. You can also visit X10’s Wiki
Also see our AirPad Forums at: http://forums.x10.com To turn your AirPad on
Press and hold the POWER button on the top of the unit until the Android logo appears on the screen. Release the button and wait while the unit “boots up.” Then swipe the lock icon to the right with your finger to unlock it.
To suspend the AirPad (Sleep mode)
Note that this still uses power and can run the battery down quite quickly if
To turn the AirPad completely off (shut it down)
Press and hold the round POWER button on the top of the unit until you see a screen that shows the option to Power off. Touch that button on the screen. Then touch OK. Next time you power on you will need to follow the steps above. If however the AirPad was just “asleep” then just pressing the POWER button displays a screen where you can swipe the lock icon with your finger to unlock it.
6
Accessing the System Settings
Throughout this owner’s manual we’ll use a couple of different methods for accessing the System Settings section. There are several ways to get to the System Settings, either way works fine, and it’s up to you which method you prefer:
Method 1
1.On your Home screen, touch 
(top right of the screen).
2.Touch on the Settings icon. 
Method 2
1.On your Home screen, touch the hard Menu key, to the bottom right of the screen, below the hard Home key.
2.A
7