Before Setting Surface Controls

Locations of the Gas Surface Burners

The STANDARD sized burners are used for most surface cooking needs. These burners are located at the left and right rear positions on the cooktop.

The SIMMER burner is used to simmering delicate aliments as chocolate, sauces, etc. This burner is located at the center rear position on the cooktop

The POWER burners are best used for bringing large quantities of liquid rapidly up to temperature or when preparing larger quantities of food. These burners are located at the left and right front positions on the cooktop.

Placement of Burner Bases and Caps

Place the burner base over each gas orifice, matching the burner base size with

the gas

orifice size. Place the burner

cap

Grate Pin

on each

burner base,

again matching

the

 

cap size

to the burner

base size. The cap

 

for each

Burner has a

inner locating

ring

 

Make sure each burner cap is properly aligned and level.

Turn the burner on to deter-

mine if it will light. If the burner

does not light, contact a Sears Service Center. Do not service

which locates the burner cap in the center

the sealed burner yourself.

of the burner.

Grate

Burner

Ca

Burner

 

Gas

Orifice

Electrode must be located

properly in slot of each

Burner Base

Alignment fork

Placement of Burner Grates

Cen_r

Alignment

Finger

Place grate over the burners. Place the alignment fork of the center grate over the alignment finger of the side grates. Align the tips under each center of the grate to the holes on the burner caps. The tip should fit in the holes. Make sure that each tip fits in the burner cap of each of the front and rear burners.

S / 4_.--Cooktop

10

Page 10
Image 10
Kenmore 790.75603 manual Before Setting Surface Controls, Locations of the Gas Surface Burners, Placement of Burner Grates