Setting Oven Controls
Setting the Clock
The (_ pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash with "PF" (power failure, See Figure 1).
When PF appears in the display, | press _, | PF will disappear. |
|
|
|
| Figure 1 |
INSTRUCTIONS | PRESS | DISPLAY | |
To set the clock (example | below for 1:30) |
| |
1.Press @. "CLO" will appear in the display (Figure 2).
2, Press Q Q padstosetthetimeofdayto1:30
(Figure 3). "CLO" will stay in the display. Press START."CLO"
will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1.Press and hold @ for 7 seconds. "CLO" will appear in the
display. After 3 seconds I_1will appear in the display indicating that the cooktop lockout is active (Figure 5). CONTINUE holding the pad until "12h" (Figure 6) or "24h" (Figure 7) appears in the display and the control beeps once.
2. Press _ | to switch between the 12 and 24 hour time of day |
v
display. The display will show either "12h" (Figure 6) or "24h" (Figure 7).
3. Press STARTto accept the change or press _ to reject the
v
change. I_1will disappear from the display.
4.Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours.
Figure 2
Figure 3
(@
for 7 seconds
Figure 4
@
Figure 5
START or @
Figure 6
Figure 7
15
