Seagate U Series 9 CE manual

Page 4

©2003– 2004, Seagate Technology LLC All rights reserved Publication number: 100271705, Rev. F

May 2004

Seagate, Seagate Technology, and the Seagate logo are registered trademarks of Seagate Technology LLC. SeaTools, SeaFONE, SeaBOARD, and SeaTDD are either registered trademarks or trademarks of Seagate Technology LLC. Other product names are registered trademarks or trademarks of their owners.

Seagate reserves the right to change, without notice, product offerings or specifications. No part of this publication may be reproduced in any form without written permission of Seagate Technology LLC.

Image 4

Contents Series 9 ce Page Series 9 ce Page Revision status summary sheet Page Contents Series 9 ce Product Manual, Rev. F List of Figures Viii Series 9 ce Product Manual, Rev. F Introduction Series 9 ce Product Manual, Rev. F Drive specifications Specification summary tableSeries 9 ce Product Manual, Rev. F Default logical geometry LBA modeFormatted capacity Physical organizationPhysical characteristics Power specificationsSeek time Start/stop timesPower consumption Spinup powerSeek mode Read/write power and currentTypical current profile Typical 5V startup and operation current profilePower-management modes Active modeIdle mode Sleep modeEnvironmental specifications Acoustics Reliability Electromagnetic immunityFluid Dynamic Bearing FDB motor acoustics Agency certification Page Configuring and mounting the drive Handling and static discharge precautionsBreather filter hole precautions Breather filter hole locationJumper settings Master/slave configurationDrive as master with a non-ATA-compatible slave Cable-select optionDrive mounting Ultra ATA/100 cableMounting dimensions-top, side and end view Series 9 ce Product Manual, Rev. F ATA interface signals and connector pins ATA interfaceO pins and supported ATA signals Supported ATA commands Command name Command code in hex ATA-standard commandsCommand name Command code in hex Identify Device command Word Description ValueXx07H Description if bit is set to Bit Word Set Features command 0CH4 S.M.A.R.T. commands Code in features Register A.R.T. commandSeries 9 ce Product Manual, Rev. F Seagate Technology support services Internet MySeagate Reseller.seagate.comPresales Support Technical SupportWarranty Service Authorized Service CentersCall Center Toll-free Direct dial Americas +1-405-324-47301 +1-405-324-4704Americas SEAGATE2 +1-405-324-47003 +1-405-324-4702 Call Center Toll-free Direct dial FAX / InternetCall Center Presales and Technical Support Warranty Service FAX Services-All Europe toll callToll-Free Support Numbers Asia/Pacific Support Services Series 9 ce Product Manual, Rev. F Index NumericsPage Page Series 9 ce Product Manual, Rev. F Page Seagate Technology LLC