Seagate ST980813AS Configuring and mounting the drive, Handling and static-discharge precautions

Page 25

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static-discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

•Keep the drive in the electrostatic discharge (ESD) bag until you are ready for installation to limit the drive’s exposure to ESD.

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive only by its edges or frame.

•The drive is fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

Momentus 7200.2 SATA Product Manual, Rev. E

19

Image 25

Contents Momentus 7200.2 Sata Page Contents Momentus 7200.2 Sata Product Manual, Rev. E List of Figures Page Introduction About the Serial ATA Sata interface Specification summary table Drive specificationsWill display the warranty information for your drive LBA mode Default logical geometryFormatted capacity Cylinders Read/write heads Sectors per track 16,383Physical organization Physical characteristicsRecording and interface technology Start/stop times Seek timeTypical seek times Typical seek times msec Read WritePower specifications Conducted noise Typical current profileVoltage tolerance Power management modes Power-management modesActive mode Idle modeEnvironmental specifications Operating shock ShockNonoperating shock VibrationElectromagnetic immunity AcousticsDrive level acoustics Radio frequency environmentsSafety certification Free Fall Protection featureReliability Agency certificationAustralian C-Tick N176 Korean RRLFCC verification Corrosive environment超出 Environmental protectionPage Momentus 7200.2 Sata Product Manual, Rev. E Handling and static-discharge precautions Configuring and mounting the driveSerial ATA cables and connectors Configuring the driveDrive mounting Drive dimensionsMomentus 7200.2 Sata Product Manual, Rev. E Serial ATA Sata interface Serial ATA connector pin definitionsSegment Pin Function Definition P10 Ground 2nd mate P11 Reserved Pin Function DefinitionCommand name Command code in hex ATA-standard commands Supported ATA commandsATA-standard power-management commands Command name Command code in hexATA-standard security commands Word Description Value Identify Device commandXxxxH Bit Word Description if bit is set to Bit WordSet Features command values Set Features commandA.R.T. commands 3 S.M.A.R.T. commandsCode in features register A.R.T. command Momentus 7200.2 Sata Product Manual, Rev. E Internet Seagate Technology support servicesPresales Support Technical SupportData Recovery Services Authorized Service Centers Warranty ServiceData Recovery Services Call Center Toll-free Direct dial Index ITE Sata Momentus 7200.2 Sata Product Manual, Rev. E Page Seagate Technology LLC