Seagate ST9120310ASG, ST980310ASG, ST9320320AS, ST9250320AS manual Configuring and mounting the drive

Page 25

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static-discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

•Keep the drive in the electrostatic discharge (ESD) bag until you are ready for installation to limit the drive’s exposure to ESD.

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive only by its edges or frame.

•The drive is fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

Momentus 5400.5 SATA Product Manual, Rev. B

17

Image 25

Contents Momentus 5400.5 Sata Page Momentus 5400.5 Sata Product Manual, Rev. B Momentus 5400.5 Sata Product Manual, Rev. B Contents Momentus 5400.5 Sata Product Manual, Rev. B List of Figures Page Introduction About the Serial ATA interface Specification summary table Drive specificationsDrive specifications LBA mode Default logical geometryFormatted capacity Cylinders Read/write heads Sectors per track 16,383Drive specification Physical characteristicsPhysical organization Recording and interface technologyStart/stop times Seek timeTypical seek times Typical seek times msec ReadPower specifications Deferred spinup Typical current profileConducted noise Voltage toleranceEnvironmental specifications Wet bulb temperature Temperature gradientHumidity Relative humidity AltitudeOperating shock ShockNonoperating shock VibrationAcoustics Drive A-weighted Sound Power Levels SWL, BAElectromagnetic immunity Test for Prominent Discrete Tones PDTs Safety certification Free Fall Protection feature Reliability Agency certificationAustralian C-Tick N176 Korean RRLFCC verification European Union Restriction of Hazardous Substances RoHS Environmental protectionChina Restriction of Hazardous Substances RoHS Directive Handling and static-discharge precautions Configuring and mounting the driveSerial ATA cables and connectors Configuring the driveTop cover stiffness/deflection Drive mountingMomentus 5400.5 Sata Product Manual, Rev. B Signal Serial ATA connector pin definitionsSerial ATA Sata interface Segment Pin Function DefinitionP10 Ground 2nd mate P11 Reserved Pin Function DefinitionCommand name Command code in hex ATA-standard commands Supported ATA commandsCommand name Command code in hex Momentus 5400.5 Sata Product Manual, Rev. B Word Description Value Identify Device commandXx7FH Bit Word Description if bit is set to Bit WordSet Features command values Set Features commandAAH A.R.T. commands 3 S.M.A.R.T. commandsCode in features register A.R.T. command Momentus 5400.5 Sata Product Manual, Rev. B Internet Seagate Technology support servicesPresales Support Technical SupportData Recovery Services Authorized Service Centers Warranty ServiceData Recovery Services Call Center Toll-free Direct dial Index ITE Sata Momentus 5400.5 Sata Product Manual, Rev. B Page Seagate Technology LLC