Seagate ST9320310AS Shock, Operating shock, Nonoperating shock, Vibration, Operating vibration

Page 20

3.10.5Shock

All shock specifications assume that the drive is mounted securely with the input shock applied at the drive mounting screws. Shock may be applied in the X, Y or Z axis.

3.10.5.1Operating shock

These drives comply with the performance levels specified in this document when subjected to a maximum operating shock of 350 Gs based on half-sine shock pulses of 2ms. Shocks should not be repeated more than two times per second.

3.10.5.2Nonoperating shock

The nonoperating shock level that the drive can experience without incurring physical damage or degradation in performance when subsequently put into operation is 1000 Gs based on a nonrepetitive half-sine shock pulse of 1ms duration.

3.10.6Vibration

All vibration specifications assume that the drive is mounted securely with the input vibration applied at the drive mounting screws. Vibration may be applied in the X, Y or Z axis.

3.10.6.1Operating vibration

The maximum vibration levels that the drive may experience while meeting the performance standards speci- fied in this document are specified below.

5–500 Hz

1.0 G (0 to peak). Max displacement may apply below 10 Hz.

3.10.6.2Nonoperating vibration

The maximum nonoperating vibration levels that the drive may experience without incurring physical damage or degrada- tion in performance when subsequently put into operation are specified below.

5–500 Hz:

5.0 Gs (0 to peak). Max displacement may apply below 22 Hz.

14	Momentus Product Manual, Rev. D

Image 20

Contents Momentus Revision history Revision DateContents Momentus Product Manual, Rev. D List of Figures Page Seagate Technology support services Seagate Online Support and ServicesByte/sector models Introduction4K byte/sector models About the Serial ATA interface Drive specifications for 640, 500 and 400GB models Drive specificationsSpecification summary table To 12,192 m -1000 ft to 40,000 ft Drive specifications for 320, 250 and 160GB models Drive specifications for 320, 250 and 160GB models Default logical geometry LBA modeFormatted capacity Physical organizationPhysical characteristics Recording and interface technologySeek time Typical seek timesPower specifications Start/stop timesTypical current profile Deferred spinupConducted noise Voltage tolerancePower-management modes Power management modesActive mode Idle modeEnvironmental specifications Shock Operating shockNonoperating shock VibrationDrive A-weighted Sound Power Levels SWL, BA AcousticsElectromagnetic immunity Test for Prominent Discrete Tones PDTsSafety certification Measurement type SpecificationReliability Agency certificationFCC verification Korean RRLAustralian C-Tick N176 Environmental protection Corrosive environmentEuropean Union Restriction of Hazardous Substances RoHS China Restriction of Hazardous Substances RoHS DirectiveConfiguring and mounting the drive Handling and static-discharge precautionsConfiguring the drive Serial ATA cables and connectorsDrive mounting Top cover stiffness/deflectionMeasurements shown in are in inches Serial ATA connector pin definitions SignalSerial ATA Sata interface Segment Pin Function DefinitionPin Function Definition P10 Ground 2nd mate P11 ReservedSupported ATA commands Command name Command code in hex ATA-standard commandsCommand name Command code in hex ATA-standard security commandsIdentify Device command Word Description ValueXx07H Description if bit is set to Bit Set Features command Set Features command valuesCode in features register A.R.T. command 3 S.M.A.R.T. commandsM.A.R.T. commands Momentus Product Manual, Rev. D Index Page Page Momentus Product Manual, Rev. D Page Seagate Technology LLC