Seagate ST9320312AS manual Serial ATA Sata interface, Serial ATA connector pin definitions, Signal

Page 29

5.0Serial ATA (SATA) interface

These drives use the industry-standard Serial ATA interface that supports FIS data transfers. It supports ATA programmed input/output (PIO) modes 0–4; multiword DMA modes 0–2, and Ultra DMA modes 0–6. The drive also supports the use of the IORDY signal to provide reliable high-speed data transfers.

For detailed information about the Serial ATA interface, refer to the “Serial ATA: High Speed Serialized AT Attachment” specification.

5.1Hot-Plug compatibility

Momentus drives incorporate connectors which enable you to hot plug these drives in accordance with the Serial ATA: High Speed Serialized AT Attachment specification revision 2.0. This specification can be down- loaded from http://www.serialata.org. This device requires a COMRESET from the host after a hotplug event.

5.2Serial ATA device plug connector pin definitions

Table 8 summarizes the signals on the Serial ATA interface and power connectors.

Table 8:	Serial ATA connector pin definitions

Segment	Pin	Function	Definition

	S1	Ground	2nd mate

	S2	A+	Differential signal pair A from Phy

	S3	A-

	S4	Ground	2nd mate

	S5	B-	Differential signal pair B from Phy

	S6	B+
Signal
Signal	S7	Ground	2nd mate

Key and spacing separate signal and power segments

Momentus Product Manual, Rev. D

23

Image 29

Contents Momentus Revision Date Revision historyContents Momentus Product Manual, Rev. D List of Figures Page Seagate Online Support and Services Seagate Technology support servicesByte/sector models Introduction4K byte/sector models About the Serial ATA interface Drive specifications for 640, 500 and 400GB models Drive specificationsSpecification summary table To 12,192 m -1000 ft to 40,000 ft Drive specifications for 320, 250 and 160GB models Drive specifications for 320, 250 and 160GB models LBA mode Default logical geometryFormatted capacity Physical organizationRecording and interface technology Physical characteristicsSeek time Typical seek timesStart/stop times Power specificationsDeferred spinup Typical current profileConducted noise Voltage tolerancePower management modes Power-management modesActive mode Idle modeEnvironmental specifications Operating shock ShockNonoperating shock VibrationAcoustics Drive A-weighted Sound Power Levels SWL, BAElectromagnetic immunity Test for Prominent Discrete Tones PDTsMeasurement type Specification Safety certificationReliability Agency certificationFCC verification Korean RRLAustralian C-Tick N176 Corrosive environment Environmental protectionEuropean Union Restriction of Hazardous Substances RoHS China Restriction of Hazardous Substances RoHS DirectiveHandling and static-discharge precautions Configuring and mounting the driveSerial ATA cables and connectors Configuring the driveTop cover stiffness/deflection Drive mountingMeasurements shown in are in inches Signal Serial ATA connector pin definitionsSerial ATA Sata interface Segment Pin Function DefinitionP10 Ground 2nd mate P11 Reserved Pin Function DefinitionCommand name Command code in hex ATA-standard commands Supported ATA commandsATA-standard security commands Command name Command code in hexWord Description Value Identify Device commandXx07H Description if bit is set to Bit Set Features command values Set Features commandCode in features register A.R.T. command 3 S.M.A.R.T. commandsM.A.R.T. commands Momentus Product Manual, Rev. D Index Page Page Momentus Product Manual, Rev. D Page Seagate Technology LLC