Seagate ST31000424CS, ST3250312CS, ST3250412CS, ST3500414CS manual Configuring and mounting the drive

Page 27

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static-discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive by its edges or frame only.

•The drive is extremely fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

Video 3.5 HDD Product Manual, Rev. J

21

Image 27

Contents Video 3.5 HDD Revision Date Sheets affected or comments Revision historyPipeline HD.2 Series Sata Product Manual, Rev. J Pipeline HD.2 Series Sata Product Manual, Rev. J Contents Pipeline HD.2 Series Sata Product Manual, Rev. J Introduction About the Serial ATA interface Specification summary tables Drive specificationsDrive specification ST31000424CS ST31000322CS Drive specifications summary for 1000GB modelsVideo 3.5 HDD Product Manual, Rev. J Drive specifications summary for 500 and 320GB models Video 3.5 HDD Product Manual, Rev. J Drive specification ST3250412CS ST3250312CS ST3160316CS Drive specifications summary for 250 and 160GB modelsVideo 3.5 HDD Product Manual, Rev. J Recording and interface technology Default logical geometryLBA mode Formatted capacityPhysical characteristics Seek timeStart/stop times Power specifications Typical current profiles Conducted noiseVoltage tolerance Sleep mode Power management modesActive mode Idle modeEnvironmental specifications Vibration ShockOperating shock Non-operating shockTest for Prominent Discrete Tones PDTs Drive A-weighted Sound Power Levels SWL, BAAcoustics emissions Electromagnetic immunityAnnualized Failure Rate AFR Safety certificationReliability Agency certificationKorean RRL Australian C-Tick N176FCC verification Environmental protection Corrosive environmentChina Restriction of Hazardous Substances RoHS Directive Handling and static-discharge precautions Configuring and mounting the driveSerial ATA cables and connectors Configuring the driveDrive mounting Mounting dimensions for 1000GB modelsMounting dimensions for 500, 320, 250 and 160GB models Hot-Plug compatibility Serial ATA Sata interfacePin Function Definition Serial ATA device plug connector pin definitionsSerial ATA connector pin definitions SignalSupported ATA commands Supported ATA commandsCommand name Command code in hex F3H Word Description Value Identify Device commandXx07H Bit Word Description if bit is set to Bit WordIdle Immediate command with Iunload faeture is supported Set Features command values Set Features command3 S.M.A.R.T. commands M.A.R.T. commandsCode in features register A.R.T. command Seagate Technology support services Warranty Service Data Recovery Services Authorized Service CentersData Recovery Services Call Center Toll-free Direct dial Index RRL Page Video 3.5 HDD Product Manual, Rev. J Page Seagate Technology LLC

Related manuals

Manual 50 pages 5.86 Kb