Seagate ST930813AM Configuring and mounting the drive, Handling and static discharge precautions

Page 27

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

•Keep the drive in the electrostatic discharge (ESD) bag until you are ready for installation to limit the drive’s exposure to ESD.

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive only by its edges or frame.

•The drive is fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

3.2Jumper settings

3.2.1Master/slave configuration

Use the options jumper block shown in Figure 3 to configure the drive for operation. This jumper block is the 4-pin header adjacent to pins 1 and 2 of the I/O signal pins. For additional information about using the Cable select option, see Section 3.2.2.

The “Drive is master (or single drive)” option is the default setting.

Drive is master (or single drive)

Drive is slave

Cable select

Figure 3. Jumper settings

EE25 Series Product Manual, Rev. E

21

Page 26 Page 28
Image 27
Page 26 Page 28
Contents EE25 Series Page Contents EE25 Series Product Manual, Rev. E List of Figures EE25 Series Product Manual, Rev. E Introduction EE25 Series Product Manual, Rev. E Specification summary Drive specificationsAftermarket Specifications for 40 and 30 Gbyte modelsVibration, nonoperating Drive specification ST920813AM ST920814AM Specifications for 20 Gbyte modelsEE25 Series Product Manual, Rev. E Physical organization Default logical geometryLBA mode Formatted capacitySeek time Physical characteristicsTechnology Specification Recording and interface technology85C 25C 20C 30C Read seek times vs temperature 85C 25C 20C 30CStart/stop times Msec Typical MaxPower specifications Typical current profile Conducted noiseVoltage tolerance Sleep mode Power-management modesActive mode Idle modeAltitude Environmental specificationsShock Operating shockNonoperating shock Operating vibration Acoustic mode Idle Normal Seek Performance SeekAcoustics VibrationTest Description Performance Reference Level Standard Measurement type SpecificationElectromagnetic immunity ReliabilityAgency certification Environmental protection Corrosive environmentEuropean Union Restriction of Hazardous Substances RoHS Page Master/slave configuration Configuring and mounting the driveHandling and static discharge precautions Jumper settingsCable-select option Drive mountingATA interface ATA interface signals and connector pinsSignal Name Connector Cable Contact Conductor Cable Connector Signal Name Conductor ContactCommand name Command code in hex ATA-standard commands Supported ATA commandsCommand name Command code in hex ATA-standard power-management commandsATA-standard security commands Word Description Value Identify Device commandXx07H Bit Word Description if bit is set to Bit Word0CH Set Features commandEE25 Series Product Manual, Rev. E Technical Support Seagate Technology support servicesInternet Presales SupportWarranty Service Data Recovery Services Authorized Service CentersData Recovery Services Call Center Toll-free Direct dial Numerics IndexPage Page EE25 Series Product Manual, Rev. E Page Seagate Technology LLC
Top Page Image Contents