Seagate ST3802110SCE, ST3120213SCE, ST3160212SCE, ST3250824SCE Configuring and mounting the drive

Page 29

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static-discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

•Keep the drive in the electrostatic discharge (ESG) bag until you are ready for installation.

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive by its edges or frame only.

•The drive is extremely fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

DB35.2 Serial ATA Product Manual, Rev. C

23

Image 29

Contents DB35.2 Serial ATA Page Contents DB35.2 Serial ATA Product Manual, Rev. C List of Figures Page Introduction About the Serial ATA interface Specification summaries Drive specificationsDrive specification ST3500841SCE ST3400833SCE Drive specifications for 500 and 400 Gbyte modelsBe asked to provide the drive serial number, model number or Drive specification ST3300822SCE ST3250824SCE ST3200827SCE Drive specifications for 300, 250 and 200 Gbyte modelsDrive specifications for 300, 250 and 200 Gbyte models Drive specification ST3160212SCE ST3120213SCE ST3802110SCE Drive specifications for 160, 120, and 80 Gbyte modelsDrive specifications for 160, 120, and 80 Gbyte models LBA mode Default logical geometryFormatted capacity Recording and interface technologyDB35.2 Serial ATA Product Manual, Rev. C Drive specification Physical characteristicsSeek time Typical seek times msec Read WriteStart/stop times Power specificationsTypical current profiles DC power requirementsActive mode Power-management modesIdle mode Sleep modeEnvironmental specifications Nonoperating shock AcousticsVibration Operating vibrationReliability Electromagnetic immunityRadio frequency environments Performance Reference Test Description Level StandardAgency certification Safety certificationElectromagnetic compatibility Korean RRLAustralian C-Tick N176 Environmental protectionFCC verification European Union Restriction of Hazardous Substances RoHSCorrosive environment DB35.2 Serial ATA Product Manual, Rev. C Handling and static-discharge precautions Configuring and mounting the driveBreather filter hole location Breather filter hole precautionsSerial ATA cables and connectors Configuring the driveDrive mounting Mounting dimensions-top, side and end viewHot-Plug compatibility Serial ATA Sata interfaceSerial ATA connector pin definitions Serial ATA device plug connector pin definitionsSignal Pin Function DefinitionCommand name Command code in hex Supported ATA commandsSupported ATA commands F4H Word Description Value Identify Device commandXx07H Bit Word Description if bit is set to Bit WordSet Features command values Set Features commandCode in features register A.R.T. command 3 S.M.A.R.T. commandsA.R.T. commands DB35.2 Serial ATA Product Manual, Rev. C Technical Support InternetPresales Support Data Recovery Services Call Center Toll-free Direct dial Warranty ServiceData Recovery Services Authorized Service Centers Index Pcba Sata Page Page Seagate Technology LLC