Seagate ST500LX003, 100665905, ST750LX003 Tem will display the warranty information for your drive

Table 1:	Drive specifications
Drive specification		ST750LX003	ST500LX003
Write power (watts typical)		3.2
Idle mode, low power (watts typical)		1.1
Standby mode (watts typical)		0.6 ***
Sleep mode (watts typical)		0.6 ***
Voltage tolerance (including noise)		+5V ± 5%
Ambient temperature (°C)		0 to 60 (operating)
		–40 to 70 (nonoperating)
Temperature gradient (°C per hour max)		20 (operating), 35 (nonoperating)
Relative humidity		5% to 95% (operating and nonoperating
Relative humidity gradient		30% per hour max
Wet bulb temperature (°C max)		37.7 (operating)
		40 (nonoperating)
Altitude, operating		–304.8 m to 3048 m (–1000 ft to 10,000+ ft)
Altitude, nonoperating		–304.8 m to 12,192 m (–1000 ft to 40,000+ ft)
(meters below mean sea level, max)
Shock, operating (Gs max at 2 ms)		350
Shock, nonoperating (Gs max at 2 ms)		800
Shock, nonoperating (Gs max at 1 ms)		1000
Shock, nonoperating (Gs max at 0.5 ms)		1000
Vibration, operating		1.0 G (0 to peak, 5–500 Hz)
Vibration, nonoperating		5 Gs (0 to peak, 5–500 Hz)
Drive acoustics, sound power (bels)
Idle**		2.3 (typical)
		2.5 (max)
Performance seek		2.6 (typical)
		2.7 (max)
Nonrecoverable read errors		1 per 1014 bits read
Annualized Failure Rate (AFR)		0.5%
Load/Unload (U/UL) cycles
25°C, 50% relative humidity		600,000 software-controlled power on/off cycles
		50,000 hard power on/off cycles
32°C, 80% relative humidity		600,000 software-controlled power on/off cycles
5°C, 80% relative humidity		50,000 hard power on/off cycles
5°C, 10% relative humidity
55°C, 16% relative humidity
Warranty		To determine the warranty for a specific drive, use a web browser to access the following
		web page: http://www.seagate.com/www/en-us/support/warranty_&_returns_assistance
		From this page, click on the “Verify Your Warranty” link. You will be asked to provide the
		drive serial number, model number (or part number) and country of purchase. The sys-
		tem will display the warranty information for your drive.
Supports Hotplug operation per		Yes (requires COMRESET from host after a hotplug event)
Serial ATA Revision 2.6 specification

*One Gbyte equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting.

**During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels.

***Typical notebooks will pull power to the drive when entering S3 and S4; while in the S3 and S4 states, drive sleep and drive standby modes will not contribute to battery power consumption.

Momentus XT Product Manual, Rev. D 5