28
Figure 13 shows how the terminator resistor-paks are attached on drives with differential I/O. These terminator resistor-paks, which are dual inline packages, mount in sockets in the control board. These terminators are also marked with a dot above pin 1.
If the drive is located at either end of the daisychain, ensure that it has resistor-pak(s) installed. Section 4 lists resistor-pak part numbers. Refer to information earlier in this section regarding the terminator power source jumper.
Grounding the system
Grounding the system through the power cables and I/O cables is usually sufficient to protect against noise and emissions.
Terminator
(note orientation)
Terminator
(dual inline
packages)
Terminator
Socket
Pin 1
Terminator Power
Source Jumper