39
Section 5. Maintenance
This section contains the following maintenance information:
•Observing maintenance precautions
•Arranging for depot repair
•Removing and replacing a drive
•Removing and replacing a power supply
•Packing a drive for shipment
Observing maintenance precautions
Because the drive is depot repairable, there are no
•Follow the precautions listed under “Electrostatic discharge protection” in the preface.
•Do not remove any circuit boards from the drive chassis. Return the entire drive for depot repair if any circuit board is defective. Removal of circuit boards by personnel not performing depot repair will damage components and may void the warranty.
•Do not remove the head and disc assembly (HDA) from the drive chassis. Return the entire drive for depot repair if the HDA is defective.
•Do not attempt to disassemble the HDA. It is not field repairable. If the sealed HDA is opened by personnel not performing depot repair, this will damage components and void the warranty.
•Use
•Do not handle the drive while powered up, due to the gyroscopic motion produced by discs that have not completed spinning down.
•Do not connect or disconnect the I/O cable while power is applied to the drive or other SCSI devices. If the SCSI bus is active, this will cause errors.
•Do not connect or disconnect the DC power cable while the power supply is energized.