RPB+User'sGuide
3.Installation
3.1. SetUp Switches
The SetUp Switches select the baud rate and Off Time, and enable/disable the Password feature and Read Only Mode. If switch settings are changed while the unit is powered On, press the Default Button to
Note: If Rate Switch settings are changed while the unit is powered on, new parameters will not take effect until the Default Button is pressed, or the RPB+ is powered Off and On.
Off Time: When a boot cycle is initiated, the "Off Time" determines the length of time the device will remain off until power is restored.
Password: When enabled, a password is required in order to access the RPB+ Command Mode (Default = [Enter]). To re- define the Password, refer to Section .
Read Only Mode: When e | abl d, the /P command (Define | |
Parameters) is suppress | . This allows the user to nvoke | |
On/Off/Bo | c mmands, but prevents red finition of | |
parameters | uch as the Password and | |
Switch4321 | ReadOnlyModePasswordFunctionOffTimeFunctionPortBaudRate | 240Disable1Enable0Upsecbps. | 9600Disable*Enable*5Downsecbps*. |
| Control |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
*= Factory Setting
3.2.Control Port Connection
The male, DB9 connector (labeled "RS232") is used for connection to an external modem or local PC. The RS232 Port uses a DTE configuration, similar to an AT computer. Figure 3
Pagedescribes4 the Control Port interface.