3.Highlight Silicon Image SiI 0680 ATA/133 Controller and click Properties. A message This device is working properly is displayed in the dialog box, the driver has been correctly installed. If any error message is displayed, remove Silicon Image SiI0680ATA/133Controllerandrestartyoursystem.
Windows NT 4.0
For New Windows NT 4.0 Installation
1.Install the board and follow Microsoft procedures to install Windows NT 4.0 accordingly.
2.At the Windows NT Setup screen, press F6 to specify and add the driver.
3.Press S, select Other, then press Enter.
4.Insert the driver diskette and press Enter.
5.Select Silicon Image SiI 0680 ATA/133 Controller and press Enter.
6.Press Enter to continue and follow
For Existing Windows NT 4.0 Installation
1.Install the board and boot up Windows NT 4.0.
2.Double click My Computer/Control Panel/SCSI Adapters, then click the Drivers tab.
3.Click Add… then Have Disk....
4.Insert the driver diskette, type in A:, then click OK.
5.Highlight Silicon Image SiI 0680 ATA/133 Controller and click OK.
6.Click OK, remove the driver diskette and restart NT to complete driver installation.
7