Tyan Computer TYAN S1668 user manual Bios Configuration, Entering Setup

Page 17

4. BIOS Configuration

Award's BIOS has a built in setup program that allows the user to modify the basic system configuration. This type of information is stored in the battery-backed CMOS SRAM. Entering incorrect information or for-

getting your password can lock you out of your system.(refer to 3.15 for resetting of CMOS)

4.1. Entering Setup

Power ON the computer and press <Del> immediately and you will enter Setup. The other way to enter setup is to power on the computer, when the below message appears briefly at the bottom of the screen during the post (Power On Self Test), press <Del> key or simultaneously press <Ctrl>, <Alt>, and <Esc> keys.

*TO ENTER SETUP BEFORE BOOT PRESS CTRL-ALT- ESC OR DEL KEY

If the message disappears before you respond and you wish to enter Setup, restart the system by turning it OFF then ON or by pressing "Reset" on the system case. You may also restart by simultaneously pressing <Ctrl>, <Alt>, and <Del> keys. If you do not press the keys at the correct time, the system will not boot and an error message will appear on the screen.You will be asked to,

*PRESS F1 TO CONTINUE, CTRL-ALT-ESC OR DEL TO ENTER SETUP.

Figure 4.1 will appear on the sceen. The Main Menu allows you to select from the 8 setup functions and 2 exit choices. Use the arrow keys to select among the items and press <Enter> to accept or enter each sub-menu.

S1668-ATX-001 http://www.tyan.com

17

Image 17
Contents Tyan S1668 Dual Pentium Pro ATX 440FX PCI-ISA System Board Table Of Contents Introduction Hardware Specifications/Features Environment Software SpecificationsBoard Installation VRM1 On Board Resource Setting .1 S1668 ATX Board LayoutCmos Resest/Password Reset J41Default off Jumper Settings CPU Speed J27, J21, J22, J23, and J24Dram Voltage J2, J3, J14, J15, J4, J5, J16 and J17Default CPU Clock Multiplier J21, J22, J23 and J24Selection J28 & J29 Speaker Connector J43 Keylock Connector J44Turbo Switch J47 Non-Turbo Mode Not Supported Turbo LED Connector J42 Reset Connector J45Flash Eeprom J32Default InfraRed Interface Con4 and Con5Speaker Connector Installation Soft Power On Switch J1 CPU FAN Power J49 and J50Turbo Switch Turbo LED Connector InstallationRefer to for Flash Eeprom upgrade procedures Hardware Reset Switch Connector InstallationVoltage ID for Older Pentium Pro CPUs J10 and J20 Dram InstallationBank0 Bank1 Bank2 Bank3 Total Memory TableCPU Installation Connecting the Power Supply & On/Off Switch VRM InstallationPeripheral Device Installation Entering Setup Bios ConfigurationControl Keys Getting Help Main Menu Setup Page menu/Option Page Setup MenuBios features setup Standard Cmos setupChipset features setup Power Management setupTime Standard Cmos Setup MenuDate Drive a type/Drive B type Primary/Secondary Drive typeMemory VideoHalt On Other Memory Expanded MemorySwap Floppy Drive Default value is Disabled Boot SequenceVirus warning CPU Internal Cache/External CacheBoot Up NumLock Status Default value is On Boot Up Floppy SeekChipset Features Setup ROM ISA Bios Power Management Setup Award SOFTWARE, INC Power ManagementPower Down Activities Doze ModeStandby Mode PCI Slot Configuration IRQ n assigned to Resources Controlled ByLegacy ISA PCI/ISA PnPIntegrated Peripherals Load Setup Defaults ROM ISA Bios Cmos Setup Utility Award SOFTWARE, INC IDE HDD Auto Detection Flash Writer Utility Page Flash Memory Writer Flash Memory Writer Utility Screen AwardSystem Resources Timer & DMA Channel MAP