Tyan Computer TYAN S1668 Standard Cmos setup, Bios features setup, Chipset features setup

Page 20

wStandard CMOS setup

This setup page includes all the items in a standard compatible BIOS.

wBIOS features setup

This setup page includes all of the enhanced features of Award's BIOS.

wChipset features setup

This setup page includes all the items of the 430HX chipset features.

wPower Management setup

Change, set, or disable system power management options

wPNP/PCI Configuration

This setup page allows you to modify the configuration of PCI slot parameters.

wLoad setup defaults

BIOS defaults indicate the most appropriate values of each system param- eter for your system.

wSupervisor/User Password

Change, set, or disable password. It allows you to limit access to the system and Setup.

wIntegrated Peripherals

This option lets the you enable or disable on board FDD, HDD, and I/O options.

wIDE HDD auto detection

Automatically configure hard disk parameters.

wSave and exit setup

Save changes to CMOS and exit setup

wExit without saving

Abandon all CMOS changes and exit setup.

S1668-ATX-001 http://www.tyan.com

20

Image 20
Contents Tyan S1668 Dual Pentium Pro ATX 440FX PCI-ISA System Board Table Of Contents Introduction Hardware Specifications/Features Software Specifications EnvironmentBoard Installation On Board Resource Setting .1 S1668 ATX Board Layout VRM1Jumper Settings CPU Speed J27, J21, J22, J23, and J24 Cmos Resest/Password Reset J41Default offDram Voltage J2, J3, J14, J15, J4, J5, J16 and J17Default CPU Clock Multiplier J21, J22, J23 and J24Selection J28 & J29 Speaker Connector J43 Keylock Connector J44Turbo Switch J47 Non-Turbo Mode Not Supported Reset Connector J45 Turbo LED Connector J42Flash Eeprom J32Default InfraRed Interface Con4 and Con5Soft Power On Switch J1 CPU FAN Power J49 and J50 Speaker Connector InstallationTurbo Switch Turbo LED Connector InstallationHardware Reset Switch Connector Installation Refer to for Flash Eeprom upgrade proceduresDram Installation Voltage ID for Older Pentium Pro CPUs J10 and J20Memory Table Bank0 Bank1 Bank2 Bank3 TotalCPU Installation Connecting the Power Supply & On/Off Switch VRM InstallationPeripheral Device Installation Bios Configuration Entering SetupControl Keys Setup Page menu/Option Page Setup Menu Getting Help Main MenuStandard Cmos setup Bios features setupChipset features setup Power Management setupTime Standard Cmos Setup MenuDate Primary/Secondary Drive type Drive a type/Drive B typeMemory VideoHalt On Expanded Memory Other MemoryBoot Sequence Swap Floppy Drive Default value is DisabledVirus warning CPU Internal Cache/External CacheBoot Up Floppy Seek Boot Up NumLock Status Default value is OnChipset Features Setup Power Management ROM ISA Bios Power Management Setup Award SOFTWARE, INCPower Down Activities Doze ModeStandby Mode PCI Slot Configuration Resources Controlled By IRQ n assigned toLegacy ISA PCI/ISA PnPIntegrated Peripherals Load Setup Defaults ROM ISA Bios Cmos Setup Utility Award SOFTWARE, INC IDE HDD Auto Detection Flash Writer Utility Page Flash Memory Writer Utility Screen Award Flash Memory WriterTimer & DMA Channel MAP System Resources