Tyan Computer TYAN S1668 user manual Software Specifications, Environment

Page 5

1.3 Software Specifications

 

w BIOS

Award or AMI BIOS

 

AT CMOS setup, BIOS/CHIPSET setup,

 

and hard disk utility included.

 

Support for easy BIOS upgrades with flash

 

EEPROM chip.

 

wO.S.

Operates with MS-DOS, Windows 3.x, Windows

 

for Work Groups 3.x, Windows 95, Windows NT,

 

OS/2, Novell Netware, Novell UnixWare 1.1 and

 

SCO Unix.

 

1.3 Environment

 

 

Ambient Temperature

0 to +50 C (operating)

Relative Humidity

0 to +85% (operating)

Altitude

 

0 to 10,000 feet (operating)

Vibration

 

0 to 1,000 Hz

Voltage

 

4.9 to 5.2 V

Information presented in this publication has been carefully checked for reliability; however, no responsibility is assumed for inaccuracies. The information contained in this document is subject to change without notice.

Trademarks

Award BIOS/Flash are trademarks of Award Software International Inc. AMI BIOS is a trademarks of American Megatrends Inc. IBM,PC,AT,PS/2 are trademarks of IBM Corporation INTEL,Pentium Pro are trademarks of Intel Corporation.

Copyright c 1996 TYAN Computer Corp. S1668, Titan Pro ATX.

S1668-ATX-001 http://www.tyan.com

5

Image 5
Contents Tyan S1668 Dual Pentium Pro ATX 440FX PCI-ISA System Board Table Of Contents Introduction Hardware Specifications/Features Environment Software SpecificationsBoard Installation VRM1 On Board Resource Setting .1 S1668 ATX Board LayoutCmos Resest/Password Reset J41Default off Jumper Settings CPU Speed J27, J21, J22, J23, and J24Dram Voltage J2, J3, J14, J15, J4, J5, J16 and J17Default CPU Clock Multiplier J21, J22, J23 and J24Selection J28 & J29 Speaker Connector J43 Keylock Connector J44Turbo Switch J47 Non-Turbo Mode Not Supported Turbo LED Connector J42 Reset Connector J45Flash Eeprom J32Default InfraRed Interface Con4 and Con5Speaker Connector Installation Soft Power On Switch J1 CPU FAN Power J49 and J50Turbo Switch Turbo LED Connector InstallationRefer to for Flash Eeprom upgrade procedures Hardware Reset Switch Connector InstallationVoltage ID for Older Pentium Pro CPUs J10 and J20 Dram InstallationBank0 Bank1 Bank2 Bank3 Total Memory TableCPU Installation Connecting the Power Supply & On/Off Switch VRM InstallationPeripheral Device Installation Entering Setup Bios ConfigurationControl Keys Getting Help Main Menu Setup Page menu/Option Page Setup MenuBios features setup Standard Cmos setupChipset features setup Power Management setupTime Standard Cmos Setup MenuDate Drive a type/Drive B type Primary/Secondary Drive typeMemory VideoHalt On Other Memory Expanded MemorySwap Floppy Drive Default value is Disabled Boot SequenceVirus warning CPU Internal Cache/External CacheBoot Up NumLock Status Default value is On Boot Up Floppy SeekChipset Features Setup ROM ISA Bios Power Management Setup Award SOFTWARE, INC Power ManagementPower Down Activities Doze ModeStandby Mode PCI Slot Configuration IRQ n assigned to Resources Controlled ByLegacy ISA PCI/ISA PnPIntegrated Peripherals Load Setup Defaults ROM ISA Bios Cmos Setup Utility Award SOFTWARE, INC IDE HDD Auto Detection Flash Writer Utility Page Flash Memory Writer Flash Memory Writer Utility Screen AwardSystem Resources Timer & DMA Channel MAP