IP Address | Specifies the unicast or multicast IP address that the SAP will be |
| sent to. |
|
|
Port | Specifies the IP port that the SAP will be sent to. |
|
|
Decoder Configuration
Note Be aware that any changes to the Video Output Settings (see below) on the decoder configuration page will reboot the IPR resulting in a brief loss of connectivity.
Player Settings
Minimum Buffer Size | Default = 262144 bytes. This setting will allow more data to be |
| saved before it is displayed. This can be used in networks where |
| there is a high delay or congestion in the backbone. This parameter |
| should generally be left at the default value. However, if a stream |
| will not open, try setting at a higher value. |
|
|
Buffer Duration | Default = 1000 ms. |
|
|
Output Volume | Use to set default output volume. This can be overridden, adjusted, |
| or muted using the IR Remote Control. |
|
|
14 | © 2007 VBrick Systems, Inc. |