8. TROUBLESHOOTING
| Problem | Cause | Measure |
|
| Power does not | Fuse is blown. | Replace with a fuse of the same amperage. If the fuse | |
| turn on. |
| blows again, consult your store of purchase. | |
| (No sound is |
|
|
|
| Incorrect wiring. | Consult your store of purchase. |
| |
| produced.) |
| ||
|
|
|
| |
|
|
|
|
|
| No sound output | Power antenna lead is | 1. Turn the unit off. |
|
| when operating | shorted to ground or | 2. Remove all wires attached to the power antenna | |
| the unit with | excessive current is required | lead. Check each wire for a possible short to | |
| amplifiers or | for | ground using an ohm meter. |
|
| power antenna | or power antenna. | 3. Turn the unit back on. |
|
| attached. |
| 4. Reconnect each amplifier remote wire to the power | |
|
|
| ||
|
|
| antenna lead one by one. If the amplifiers turn off | |
|
|
| before all wires are attached, use an external relay | |
|
|
| to provide | |
|
|
| required). |
|
General |
|
|
|
|
Nothing happens | The microprocessor has | Turn off the power, then press the | Reset button | |
| when buttons are | malfunctioned due to noise, | [RELEASE] button and remove |
|
| pressed. | etc. | the DCP. |
|
|
|
| Press the reset button for about 2 |
|
| Display is not |
| seconds with a thin rod. |
|
| accurate. |
| If the RESET button is pressed |
|
|
|
| when a disc is loaded, please |
|
|
|
| eject the disc and load it once |
|
|
|
| again before attempting to play it. |
|
|
|
|
| |
|
| DCP or main unit connectors | Wipe the dirt off with a soft cloth moistened with | |
|
| are dirty. | cleaning alcohol. |
|
|
|
|
| |
| No sound heard | The speaker protection circuit | 1. Turn down sound volume. Function can also be | |
|
| is operating. | restored by turning the power off and on again. | |
|
|
| (Speaker volume is reduced automatically when | |
|
|
| the speaker protection circuit operates). | |
|
|
| 2. If the sound is muted again, consult our service | |
|
|
| department. |
|
|
|
|
|
|
English
CZ309 27