Basic Operations

6. OPERATIONS

Note:

• Be sure to read this chapter referring to the front diagrams of chapter “3. CONTROLS” on page 5.

English

CAUTION

Be sure to lower the volume before switching off the unit power or the ignition key. The unit remembers its last volume setting.

Turning on/off the power

1.Press the [SRC] button to turn on the power.

2.Press and hold the [SRC] button for 1 second or longer to turn off the power for the unit.

Note:

•System check

The first time this unit is turned on after the wire connections are completed, it must be checked what equipment is connected. When the power is turned on, the “S-CHECK” appears in the display, then the unit returns to the clock display mode. The system check starts within the unit. Then press the [SRC] button again, the unit turn to the radio mode.

Selecting a mode

1.Press the [SRC] button to change the operation mode.

2.Each time you press the [SRC] button, the operation mode changes in the following order:

Radio ➜ (Satellite radio) ➜ CD/MP3/WMA/ AAC ➜ USB/MTP/iPod ➜ (CD changer) ➜ (DVD changer) ➜ (TV) ➜ AUX ➜ Radio...

∗External equipment not connected with CeNET is not displayed.

∗iPod/MTP can connect to this unit via USB SLOT.

Adjusting the volume

1.Turning the [ROTARY] knob clockwise increases the volume; turning it counterclockwise decreases the volume.

∗The volume level is from 0 (minimum) to 33 (maximum).

Switching the display

Press the [DISP] button to select the desired display.

Sound Adjustment

You can adjust a sound effect or tone quality to your preference.

To change sound setting

1.Press the [SOUND] button to switch to the sound adjustment selection display.

∗The factory default sound setting is “Z- EHCR”.

2.Then press the [x] or [v] button to

select the sound adjustment mode. Each time you press the [x] or [v] button, the sound adjustment mode changes as following order:

“Z-EHCR”↔ “BASS” ↔ “TREBLE” ↔

“BALANCE” ↔ “FADER” ↔ “S-W LPF” ↔ “S-W VOL” ↔ “HPF”

∗In the case of display blinking “ENT”, you can press the [ ] button to adjust the setting value.

∗The sound adjustment mode will be displayed for 2 seconds before showing the sound setting.

3.Press the [w] or [z] button to adjust the selected audio mode.

4.After completing settings, press the

[SOUND] button to return to the previous mode.

●Setting the Z-Enhancer Plus

This unit is provided with 4 types of sound tone effects stored in memory.

Select the one you prefer.

∗The factory default setting is “OFF”.

2-1. Select “Z-EHCR”.

CZ3099