Rear Panel Connections

Output Impedance: Frequency Response: Dynamic Range, typical: Dynamic Range, worst-case: Idle Channel Noise (A-weighted): THD+N @ 997 Hz:

THD+N (20 Hz to 20 kHz):

Inter-channel Isolation:

<200 ohms (electronically balanced) 20 Hz to 20 kHz, ±0.5 dB

102 dB FS @ 997 Hz

>100 dB FS @ 997 Hz

104 dB FS (20 Hz to 20 kHz), typical

.001 %, typical <.006 %, worst-case >85 dB separation

Connector Type:	XLR, male
Audio Resolution (Rx):	16, 20, 24-bit (auto-configuring)
Output Impedance:	110 ohms (balanced), transformer coupled
REAR PANEL CONNECTIONS
Female RJ-45	100BASE-TX Ethernet receptacle for CAT-5 UTP cable.
Female DB-9	Provides serial bridge, RS-232 to Ethernet (requires host PC and straight-through cable)
Female BNC (x2):	“Sync Output” provides word clock output and keep-alive signal for redundant operation.
	“Slave Input” provides external word clock input and receives keep-alive signal for redundant
	operation.
IEC male power receptacle:	For AC lines power connection
DELAY SPECIFICATIONS
Component	Sample Delay	Timing Delay
A/D converter (AK5392)	38	792 microseconds
D/A converter (CS4390)	25	521 microseconds
AES transmitter (CS8401)	2	42 microseconds
AES receiver (CS8411)	2	42 microseconds
Sample rate converter (AD1890)	37	770 microseconds
Audio buffering (CobraNet core)	256	5.333 milliseconds
Network device delay
Device	Forwarding Delay
Class II repeater (network hub)	<460 nanoseconds
Category 5 UTP cable	approximately 11 nanoseconds per linear meter (round trip)
Multimode fiber optic cable	approximately 10 nanoseconds per linear meter (round trip)

Network switch: refer to CobraNet store and forward delay specification

Specifications Subject To Change Without Notice