QSC Audio S series user manual Required tools #2 Phillips screwdriver

Page 11

Installation: Pre-Installation Level Setting (RAVE 160/161/188 only)

PRE-INSTALLATION PREPARATION: ANALOG AUDIO SIGNAL LEVELS (RAVE 160/161/188 ONLY)

The RAVE models supporting analog audio inputs and/or outputs may require signal level setup to achieve optimum performance. Level setup must be configured before rack-mounting the units. The digital AES3 (digital audio) models do not require any adjustment. Level adjustments are made by configuring internal jumpers on the main circuit board. For access to these jumpers, you must first remove the top cover of the RAVE unit as follows.

NOTE: If synchronizing to an AES3 (AES/EBU) source, see page 18 for AES3 jumper settings.

To remove cover, first detach the AC power cord, then remove screws from top, bottom, and sides. The arrows in this picture point to the 17 screw locations.

Required tools: #2 Phillips screwdriver.

CAUTION: Detach the power cord before removing the top cover. Dangerous voltages within the enclosure may be of sufficient magnitude to constitute a risk of electric shock to humans.

Then lift the rear edge of the top cover about ¼ inch, or 6 mm, and slide the cover forward about 2 inches, or 5 cm. Lift the cover straight up to remove it from the chassis.

Reverse this procedure to reinstall the cover.

Be sure to take proper protective measures, such as working on an antistatic surface and wearing a grounding wrist strap, before touching any circuitry inside.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Rave Erklärung DER Graphischen Symbole Explanation of Graphical SymbolsExplication DES Symboles Graphiques Table of Contents Introduction Overview Introduction Illustration of Rave units Introduction Glossary Introduction Glossary Introduction How It Works Outs Introduction How It WorksChannel Routing Introduction Channel RoutingRequired tools #2 Phillips screwdriver Input Level Sensitivity Rave 161s-24 and 188s-24 only Ethernet Connection ALL Models Installation Rack MountingConnections 100BASE-TX Ethernet Rack Mounting ALL ModelsAnalog Audio Connections Connections Analog Audio Inputs/Outputs Rave 160/161/188Digital Audio Connections Connections Digital Audio Inputs/Outputs Rave 80/81/88SLAVE/SYNC Input AC PowerFuses RS-232 Port Redundant ConfigurationSynchronizing to AES/EBU Synchronizing to AES/EBU Status Indicators Operation Network Activity Status IndicatorsTx Error Audio Metering Operation Audio Signal Level IndicatorsAudio Signal Level Indicators Bundle Activity Error ReportingBundle Assignment Routing Operation Program/Software Kill, RoutingProgram and Software Kill Operation Routing Switched Networks Network Design Considerations Switched Networks Repeater Networks Network Design Considerations Repeater NetworksGeneral SpecificationsRear Panel Connections Audio Buffering RS-232 Port Information AppendixEthernet Cabling Network Hardware Manufacturers CAT-5 UTP Manufacturers Appendix ResourcesProduct Warranty How to Contact QSC Audio Products
Top Page Image Contents