Omega Engineering EN-EIC-325-PCI manual Next, Yes

Page 32

APPENDIX C: CARD INSTALLATION

?Install your card only after driver installation (section 3.1.1).

Win95/98

1. Shut down your PC (i.e., power off).

2. Insert the new card into a free PCI slot.

3. Turn on your PC.

4. During the Windows 95/98 startup, the following window will appear:

Add New Hardware Wizard

This wizard searches for new drivers for: PCI Card

A device driver is a software program that makes a hardware device work.

Click:

Next

5. Select the following option:

Display a list of all the drivers in a specific location, so you can select the driver you want.

...and click:

Next

6.In the Devices List select:

Other Devices and click:

Next

7.Wizard shows a ʻ?ʼ and displays in the ʻModelsʼ square:

Unsupported Device Click:

Next

8.Wizard shows an ʻUpdate Driver Warningʼ:

The driver that you have chosen was not written specifically for the selected hardware and may not work correctly. Installing this driver is not recommended. Are you sure you want to use this driver?

This is normal. Click:

Yes

30

Image 32

Contents User’s Guide Servicing North America Model Table of Contents Section Encoder Interface Each Encoder Interface includes the following elementsSoftware Inputs Cards Hardware I/OEncoder Inputs PIN LAY-OUTFunction Type Pin No Encoders Event Signals and General OutputsLogical Inputs Installation CPPVB folders Page WinSysPath folder WinSysPath is Page Page Introduction to the Functions Card Level Functions Chip Level FunctionsBrief Name Arguments in C Syntax Full Description SetActiveChipAll the following functions refer to that active chip GetActiveChipBrief Description Name InputsBrief Arguments in C Syntax Full DescriptionShort EncoderNumber Short ClocksPerCycle Short EncoderNumberSetIndexPulsePolarity Short PolarityGetIndexPulsePolarity CounterSetSetPoint Long SetPointSetPoint GetSetPointSetEncoderEventFlag SourceGetEncoderEventFlag PolaritySetHoldEncoderEvent FlagGetHoldEncoderEvent ClearEncoderEventResetPositionCounter Short OutputsMirrorReadPositionCounter Long* PositionCounterAvailable only for RequestPositionCounter Polarity Introduction Encoder CountersInput Signals from the Encoders Square wave signalSine wave signal GeneralSoftware GeneralConnector Wiring for the Inputs Connector Wiring for the Outputs Next YesWinNT FinishPage Page Page Page Page Page Page Appendix D Product Development WARRANTY/DISCLAIMER Shop online at omega.com