Omega Engineering EN-EIC-325-PCI manual Logical Inputs, Function Type Pin No

Page 8

Logical Inputs

Function

D-Type

44 pin No.

Input #2	16
Input #1	1
Input #3	19
Input #4	34
Input #5	37
Input #11	8
Input #7	26
Input #6	11
Input #8	29
Input #9	44
Input #10	15
GND	30

ENCODERS' EVENT SIGNALS AND GENERAL OUTPUTS

Function

D-Type

9 pin No.

VExt+			1
		Encoder A	6
Event Signal		Encoder B	2
Event Signal		Encoder C	7
		Encoder C	7
		Encoder D	3
General Output		Output #1	8
General Output		Output #2	4
		Output #3	9
VExt	–		5

Notes:

1.Max. (consumed) current 15 mA + outputs drained current.

2.+/– VExt = 5–24 V.

6

Image 8

Contents User’s Guide Servicing North America Model Table of Contents Section Encoder Interface Each Encoder Interface includes the following elementsSoftware Inputs Cards Hardware I/OEncoder Inputs PIN LAY-OUTFunction Type Pin No Encoders Event Signals and General OutputsLogical Inputs Installation CPPVB folders Page WinSysPath folder WinSysPath is Page Page Introduction to the Functions Card Level Functions Chip Level FunctionsBrief Name Arguments in C Syntax Full Description SetActiveChipAll the following functions refer to that active chip GetActiveChipBrief Description Name InputsBrief Arguments in C Syntax Full DescriptionShort EncoderNumber Short ClocksPerCycle Short EncoderNumberSetIndexPulsePolarity Short PolarityGetIndexPulsePolarity CounterSetSetPoint Long SetPointSetPoint GetSetPointSetEncoderEventFlag SourceGetEncoderEventFlag PolaritySetHoldEncoderEvent FlagGetHoldEncoderEvent ClearEncoderEventResetPositionCounter Short OutputsMirrorReadPositionCounter Long* PositionCounterAvailable only for RequestPositionCounter Polarity Introduction Encoder CountersInput Signals from the Encoders Square wave signalSine wave signal GeneralSoftware GeneralConnector Wiring for the Inputs Connector Wiring for the Outputs Next YesWinNT FinishPage Page Page Page Page Page Page Appendix D Product Development WARRANTY/DISCLAIMER Shop online at omega.com