Omega Engineering EN-EIC-325-PCI manual WinNT, Finish

Page 33

9.Click:

Next

10.Wizard displays:

Unsupported Device. Windows has not installed a driver for this device.

This is normal either. Click:

Finish

WinNT

1.Shut down your PC (i.e., power off).

2.Insert the new card into a free PCI slot.

3.Turn on your PC.

?For Win2K/XP instructions please refer to the following pages.

31

Image 33

Contents User’s Guide Servicing North America Model Table of Contents Section Each Encoder Interface includes the following elements Encoder InterfaceCards Hardware I/O Software InputsPIN LAY-OUT Encoder InputsEncoders Event Signals and General Outputs Logical InputsFunction Type Pin No CPP InstallationVB folders Page WinSysPath folder WinSysPath is Page Page Introduction to the Functions Chip Level Functions Card Level FunctionsSetActiveChip Brief Name Arguments in C Syntax Full DescriptionAll the following functions refer to that active chip GetActiveChipInputs Brief Description NameArguments in C Syntax Full Description BriefShort EncoderNumber Short ClocksPerCycle Short EncoderNumberShort Polarity SetIndexPulsePolarityGetIndexPulsePolarity CounterLong SetPoint SetSetPointSetPoint GetSetPointSource SetEncoderEventFlagGetEncoderEventFlag PolarityFlag SetHoldEncoderEventGetHoldEncoderEvent ClearEncoderEventShort OutputsMirror ResetPositionCounterReadPositionCounter Long* PositionCounterAvailable only for RequestPositionCounter Polarity Encoder Counters IntroductionSquare wave signal Input Signals from the EncodersSine wave signal GeneralGeneral SoftwareConnector Wiring for the Inputs Connector Wiring for the Outputs Yes NextFinish WinNTPage Page Page Page Page Page Page Appendix D Product Development WARRANTY/DISCLAIMER Shop online at omega.com