Omega DPF500 Series manual Rate, Programming Flowchart

4.2 Programming Flowchart

RUN MODE

RATE	Press the M key to enter the programming menu.
TOTAL

ENTER CODE

CLEAR TOTAL

FACTOR

DECIMAL

If panel	M
lock OFF	If panel
	lock ON

0000

ent Code

EIf code

incorrect

If code correct

E

CLR ToT

M

FDEC E

2345678

If the panel lock is on, you must enter the 4 digit lock code to gain access to the menu.

Press the key to increment each individual digit of the code.

Press the key to advance to the next digit.

Press the E key to enter the displayed code.

If the code is correct, display advances to "clr tot ", if not, display returns to run mode

Press the E key to clear the totalizer and return to the programming menu. Press the M key to skip and go to next menu item.

Press the key to step the factor decimal to the desired location. Press the E key to enter the displayed decimal location.

Press the M key to skip and keep the existing location

NOTE: For best performance and resolution choose as many decimal places as

FACTOR

TYPE

SET

20PT YES

No

No

selected

FREQUENCY for POINT # (Fr0-Fr19)

FACTOR for

POINT #

(FAC0-FAC19)

	M				possible in the K-Factor.Example: Enter a K-Factor of 1 as 1.000.
20poInt	FAC				Press the	key to choose factor type (20point or linear ).
		E			Press the E key to enter the displayed factor type.
lInear	20poInt
					Press the M key to skip and keep the existing factor type.
	M
20poInt		lInear			The FAC prompt will only appear if linear is selected or if the unit was ordered
selected	selected				without the 20 point linearization option.
FACTOR		FAC			Press the key to increment each individual digit of the factor.
				E	Press the	key to advance to the next digit.
			00		Press the E key to enter the displayed factor.
					Press the M key to skip and keep the existing factor.
YES		M
	E				The SET pnts prompt will only appear if 20point is selected. This allows users
SET pnts
					to bypass the 20 point set up and keep the existing values.
M
					Press the key to choose YES or NO.
YES					Press the E key to enter the displayedselection.
					Press the M key to skip (same as selecting NO).
selected
	Fr#				Press the key to increment each individual digit of the frequency for point
		E			#.
	#####				Press the	key to advance to the next digit.
					Press the E key to enter the displayed frequency.
If Fr1-FR19 = 0	M
					Press the M key to skip and keep the existing frequency.
					If 0 is entered, the display will advance to the next prompt (tdec).
FaC#					NOTE: Frequency/factor point pairs must be entered in ascending order of fre-
		E			quency
	#####
	M				Press the key to increment each individual digit of the factor for point #.
					Press the	key to advance to the next digit.
	# = 19				Press the E key to enter the displayed factor.
					Press the M key to skip and keep the existing factor.
					If 0 is entered, the display will advance to the next prompt (tdec).

Continue On

Next Page

8