Appendix A Factory Default Settings and Specifications
Factory Default Settings
When you first receive your WG102 Access Point, the default factory settings are set as shown below. You can restore these defaults with the Reset button on the rear panel — see “Rear Panel” on page
Feature | Factory Default Settings |
|
|
User name (case sensitive) | admin |
|
|
Password (case sensitive) | password |
|
|
Operating mode | Access point |
|
|
Access point name | netgearxxxxxx where xxxxxx are the last six digits of the |
| wireless access point's MAC address |
|
|
DHCP client disabled, it uses the default IP address | |
|
|
IP configuration | IP Address: 192.168.0.229 |
| Subnet Mask: 255.255.255.0 |
| Gateway: 0.0.0.0 |
|
|
Network Name (SSID) | |
|
|
Broadcast Network Name (SSID) | Enabled |
|
|
Disabled | |
|
|
WEP/WPA | Disabled |
|
|
MAC Access Control | Disabled |
|
|
Restricting connectivity based on MAC Access | Disabled |
Control List |
|
|
|
Time Zone | GMT |
|
|
Time Zone Adjust for Daylight Saving TIme | Disabled |
|
|
SNMP | Disabled |
|
|
VLAN (802.1Q) | Disabled |
|
|
WMM support | Disabled |
|
|