NETGEAR GS748T manual Checking the Installation, Connecting Devices to the Switch

GS748T Smart Switch Hardware Installation Guide

4.Support the weight of the switch and use four pan-head screws with nylon washers to attach it to the rack; use a #2 Phillips screwdriver to tighten the screws.

Figure 4-1 Mounting the Switch in a Rack

Step 3: Checking the Installation

Before you apply power, inspect the equipment thoroughly to:

•Verify that all cables are installed correctly.

•Check that cables are not damaged and that cable routing does not interfere with equipment to create a safety hazard.

•Ensure that all equipment is mounted properly and securely.

Step 4: Connecting Devices to the Switch

The following procedure describes how to connect devices to the switch’s RJ-45 ports. Your NETGEAR GS748T Gigabit Smart Switch contains Auto Uplink technology, which enables you to attach devices using either straight-through or crossover cables.

Installation 4-3

v1.0, January 2007